SACHS Hochleistungsfett

SECTION 2: Hazards identification

Product definition

Mixture The product is not classified, according to the Globally Harmonised System (GHS).

2.2 Label elements

Void

Hazard pictograms

Void

Signal word

Void

Hazard statements

Void

PBT Substances

Not applicable.

vPvB Substances

Not applicable. 3. Substance/mixture Chemical characterisation Mixtures Description Mixture of mineroil oil raffinates and additives.

Hazardous Ingredients

Void

Additional information

For the wording of the listed hazard phrases refer to section 16. 4. First aid measures 4.1 Description of first aid measures General information It may be dangerous to the person providing aid to give mouth-to-mouth resuscitation. If victim is unconscious: Victim to lie down and be transported in the recovery position. If required, provide artificial respiration. After inhalation Supply fresh air; consult doctor in case of symptoms After skin contact The product is not skin irritating. After eye contact Rinse opened eye for several minutes under running water. If symptoms persist, consult doctor. After swallowing Do not induce vomitting. In case of persistent symptoms consult doctor. 4.2 Information for doctor Most important symptoms and effects, Dermatitis both acute and delayed After skin contact Has a degreasing effect on the skin. Indication of any immediate medical A symptomatic therapy is to be attention and special treatment induced. needed 5. Firefighting measures 5.1 Extinguishing media Suitable extinguishing media: Foam Fire-extinguishing powder For safety reasons unsuitable The use of a water jet may cause the extinguishing agents fire to spread by splashing the burning product. Special hazards arising from the In a fire or if heated, a pressure substance or mixture increase will occur and the container may burst. Hazardous combustion products: Pressure build-up and risk of bursting when heated. Can be released in case of fire Carbon monoxide and carbon dioxide Metal oxides 5.3 Advice for firefighters Protective equipment In case of fire wear breathing equipment being independent of ambient air and suit provided full protection against chemicals. Collect contaminated fire fighting water separately. It must not enter drains. Provide sufficient fire fighting water retention. Dispose of fire debris and contaminated fire fighting water in accordance with official regulations. 6. Accidental release measures Personal precautions, protective Ensure adequate ventilation equipment and emergency Wear protective equipment. Keep procedures unprotected persons away. Particular danger of slipping on leaked/spilled product. Environmental precautions: Do not allow product to reach sewage system or water bodies. Inform respective authorities in case product reaches water or sewage system. Methods and material for containment Absorb with liquid-binding material and cleaning up (sand, diatomite, acid binders, universal binders). Dispose of the material collected according to regulations. Send for recovery or disposal in suitable containers. 6.4 Reference to other sections See Section 7 for information on safe handling See Section 8 for information on personal protection equipment. See Section 13 for information on disposal. 7. Handling and storage 7.1 Handling Precautions for safe handling Wear suitable protection equipment. Avoid contact with eyes and skin. Do not inhale gases/vapours/aerosols Information about protection against No special measures required. explosions and fires 7.2 Conditions for safe storage, including any incompatibilities Requirements to be met by Store only in the original container storerooms and containers Information about storage in one Not required common storage facility Further information about storage Keep container tightly closed and conditions store in a dry, cool and well ventilated place. Protect from heat and direct sunlight. 7.3 Specific end use(s) No further relevant information available. 8. Exposure controls/personal protection 8.1 Control parameters Components with limit values that The product does not contain any require monitoring at the workplace relevant quantities of materials with critical values that have to be monitored at the workplace. The lists that were valid during the compilation were used as basis. 8.2 Exposure controls Personal protective equipment General protective and hygienic Do not eat, drink or smoke while measures working. Wash hands during breaks and at the end of the work. Do not wear contamineted clothings outside the workplace. Ensure that washing facilities are available in the work place. Breathing equipment Not required when used as intended. Use breathing protection in case of insufficient ventilation. Protection of hands The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation Material of gloves Nitrile rubber, NBR The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Penetration time of glove material In case of a layer thickness of 0.35 mm the penetration time is longer than 480 minutes. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed. Eye protection Tightly sealed safety glasses. Body protection Wear antistatic and flame resistant clothing. 9. Physical and chemical properties 9.1 Information on basic physical and chemical properties General Information Form: Pasty Colour: Dark Brown Odour: Characteristic Odour threshold: Not determined pH: Not determined Melting point/freezing Not determined point Initial boiling point and Not determined boiling range Flash point 268°C (514.4°F) Open cup [Estimated. Based on Lubricants - Base Oils] Inflammability (solid, Not applicable gaseous) Decomposition Not determined temperature Self-inflammability Product is not selfigniting Explosive properties Product is not explosive Critical values for explosion Lower Not determined Upper Not determined Vapour pressure Not determined Density <1000 kg/m³ (<1 g/cm³) at 20°C Relative density Not determined Vapour density Not determined Evaporation rate Not determined Solubility in / Miscibility Not miscible or difficult to mix with Water Viscosity: dynamic: Not determined kinematic: Not determined Other information No further relevant information available 10. Stability and reactivity 10.1 Reactivity No further relevant information available 10.2 Chemical stability Thermal decomposition / conditions to No decomposition if used according be avoided to specifications. 10.3 Possibility of hazardous reactions No dangerous reactions known 10.4 Conditions to avoid No further relevant information available. 10.5 Incompatible materials No further relevant information available. 10.6