ARMOR

SECTION 2: Hazards identification

CAUTION! COMBUSTIBLE. KEEP AWAY FROM HEAT, SPARKS, FLAME AND ALL OTHER SOURCES OF IGNITION. ----------------------------------------------------------------------------------------- SECTION 7. 7. ACCIDENTAL ACCIDENTAL RELEASE RELEASE MEASURES MEASURES ----------------------------------------------------------------------------------------- CLEAN-UP Keep unnecessary people away; isolate hazard area and deny entry. Stay upwind, out of low areas, and ventilate closed spaces before entering. Shut off ignition sources; keep flares, smoking or flames out of hazard area. SMALL SPILLS: take up liquid with sand, earth or other noncombustible absorbent material and place in a plastic container where applicable. LARGE SPILLS: dike far ahead of spill for later disposal. For transportation related spills contact Chemtrec at 1-800-424-9300 for emergency assistance. WASTE WASTE DISPOSAL

Disposal

Dispose in accordance with applicable local, state and federal regulations. ----------------------------------------------------------------------------------------- SECTION 8. 8. HANDLING HANDLING AND AND STORAGE

Storage

Keep container tightly closed when not in use. Store in a cool, dry place. Do not store near flames or at elevated temperatures. HANDLING Read carefully all cautions and directions on product label before use. Since empty container retains residue, follow all label warnings even after container is empty. Dispose of empty container according to all regulations. Do not reuse this container. ----------------------------------------------------------------------------------------- SECTION 9. 9. TRANSPORT TRANSPORT INFORMATION INFORMATION ----------------------------------------------------------------------------------------- TRANSPORTATION Domestic: Petroleum Distillates IMDG/IMO: Petroleum Distillates, Flash point above 61 degrees C (141.8 F) ----------------------------------------------------------------------------------------- SECTION 10. EXPOSURE EXPOSURE CONTROLS/PERSONAL CONTROLS/PERSONAL PROTECTION PROTECTION ----------------------------------------------------------------------------------------- VENTILATION VENTILATION PROTECTION PROTECTION Use only with adequate ventilation to prevent build-up of vapors. Open all windows and doors. Use only with a cross ventilation of moving fresh air across the work area. If strong odor is noticed or you experience slight dizziness, headache, nausea, or eye-watering - STOP - ventilation is inadequate. Leave area immediately. RESPIRATORY RESPIRATORY PROTECTION PROTECTION For OSHA controlled work place and other regular users - Use only with adequate ventilation under engineered air control systems designed to prevent exceeding appropriate TLV. For occasional use, where engineered air control is not feasible, use properly main- tained and properly fitted NIOSH approved respirator for organic solvent vapors. A dust mask does not provide protection against vapors. SKIN SKIN PROTECTION PROTECTION Wear impermeable gloves. Gloves contaminated with product should be discarded. Promptly remove clothing that becomes soiled with product. EYE EYE PROTECTION PROTECTION Safety glasses, chemical goggles or face shields are recommended to safeguard against potential eye contact, irritation, or injury. Contact lenses should not be worn while working with chemicals. OTHER OTHER PROTECTION PROTECTION Various application methods can dictate use of additional protective safety equipment, such as impermeable aprons, etc., to minimize exposure. A source of clean water should be available in the work area for flushing eyes and skin. Do not eat, drink, or smoke in the work area. Wash hands thoroughly after use. Before reuse, thoroughly clean any clothing or protective equipment that has been contaminated by prior use. Discard any clothing or other protective equipment that cannot be decontaminated, such as gloves or shoes. ----------------------------------------------------------------------------------------- SECTION 11. 11. PHYSICAL PHYSICAL AND AND CHEMICAL CHEMICAL PROPERTIES PROPERTIES ----------------------------------------------------------------------------------------- VOLATILE VOLATILE % % 100.000 by weight ----------------------------------------------------------------------------------------- SECTION 11. 11. PHYSICAL PHYSICAL AND AND CHEMICAL CHEMICAL PROPERTIES PROPERTIES (CONTINUED) ----------------------------------------------------------------------------------------- BOILING BOILING POINT POINT GT 316.00 F 157.77 C BOILING RANGE: 316 F - 360 F VAPOR VAPOR DENSITY DENSITY (Air (Air = = 1.0) 1.0) Heavier than air EVAPORATION EVAPORATION RATE RATE Slower than ether BULK BULK DENSITY DENSITY 6.380 lbs/gal at 75 F pH pH FACTOR FACTOR N/E PHOTOCHEMICALLY PHOTOCHEMICALLY REACTIVE REACTIVE NO MAX MAX V.O.C. V.O.C. 800 grams per liter (excluding exempt solvents and water) MAX MAX VAPOR VAPOR PRESSURE PRESSURE (of the V.O.C.) 2mm Hg at 20 degrees C ----------------------------------------------------------------------------------------- SECTION 12. STABILITY STABILITY AND AND REACTIVITY REACTIVITY ----------------------------------------------------------------------------------------- INCOMPATIBILITIES Incompatible with strong oxidizing agents. DECOMPOSITION Decomposition may produce carbon monoxide and carbon dioxide. POLYMERIZATION Will not occur. STABILITY Stable. ----------------------------------------------------------------------------------------- SECTION 13. ADDITIONAL ADDITIONAL INFORMATION INFORMATION ----------------------------------------------------------------------------------------- IMPORTANT IMPORTANT NOTE NOTE The information contained herein is presented in good faith and believed to be accurate as of the effective date shown above. This information is furnished without warranty of any kind. Employers should use this information only as a supplement to other information gathered by them and must make independent determination of suitability and completeness of information from all sources to assure proper use of these materials and the safety and health of employees. Any use of this data and information must be determined by the user to be in accordance with applicable federal, state and local laws and regulations. LEGEND: PPM = parts per million MG/M3 = milligrams per cubic meter N/E or NE = none established GT = greater than N/A or NA = not applicable TCC = tag closed cup TOC = tag open cup PMCC = Pensky-Martens closed cup IDLH = Immediately Dangerous to Life and Health ALL KWIK P&D PAGE 6 6 Zen ----------------------------------------------------------------------------------------- SECTION