Note: Ingredients listed on restricted chemical lists
EC/CAS
6484-52-2
Name of the chemical
Ammonium Nitrate (AN)
Concentration
N/A
EC/CAS
7664-41-7
Name of the chemical
ammonia
Concentration
N/A
EC/CAS
229-347-8
Name of the chemical
Ammonium nitrate (AN)
Concentration
N/A
EC/CAS
231-635-3
Name of the chemical
Ammonia
Concentration
N/A
General Information
Revision date
2020-05-19
Product name
Urean 30
Emergency telephone
National advisory body/Poison Center
Icons in SDS
Company Information
company name
Yara Vlaardingen B.V
e-mail address of the competent person responsible for the Safety Data Sheet
yaraquest@yara.com
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H319
Hazard statements
Code
Statements
H319
Causes serious eye irritation
Section 2
SECTION 2: Hazards identification
1272/2008]
Product definition
Mixture
Classifications
Eye Irrit. 2, H319 The product is classified as hazardous according to Regulation (EC) 1272/2008 as amended. See Section 16 for the full text of the H statements declared above. See Section 11 for more detailed information on health effects and symptoms.
Signal word
Warning
Hazard statements
H319 Causes serious eye irritation.
Prevention
P280-a Wear eye protection. P264-a Wash hands thoroughly after handling.
Response
P305 IF IN EYES: P351 Rinse cautiously with water for several minutes. P338 Remove contact lenses, if present and easy to do. Continue rinsing. P337 If eye irritation persists: P313-a Get medical attention. EU Regulation (EC) No. Applicable, Table 65. 1907/2006 (REACH) Annex XVII - Restrictions on the manufacture, placing on the market and use of certain dangerous substances, mixtures and articles
Special packaging requirements
Containers to be fitted with Not applicable. child-resistant fastenings
Tactile warning of danger
Not applicable.
Other hazards which do not result in classification
DO NOT allow any pump handling the product to run dry or over-heat e.g. due to blockage or closed valve in the associated lines, resulting in pumping against a dead-end. Under such conditions if over-heating occurs this may cause vaporization and possible decomposition of the product. This can create pressure build-up in the pump and, if unchecked, lead to an explosion. Ensure that the pump is used correctly according to the manufacturers instructions at all times when pumping the product.
