Note: Ingredients listed on restricted chemical lists
EC/CAS
9016-87-9
Name of the chemical
4,4'-Methylendiphenyldiisocyanat tech. (Polymeres) MDI, pMDI (in Form atembarer Aerosole, A-Fraktion)
Concentration
50-60%
EC/CAS
101-68-8
Name of the chemical
4,4’-Methylenediphenyl diisocyanate
Concentration
35-45%
EC/CAS
5873-54-1
Name of the chemical
2,4’-Methylenediphenyl diisocyanate
Concentration
1-5%
EC/CAS
2536-05-2
Name of the chemical
2,2’-Methylenediphenyl diisocyanate
Concentration
1%
General Information
Revision date
2023-10-29
Product name
XCELUS XLS 500 LE Part A
1.2.1 Relevant identified uses
Component of a Foam Insulation System
Emergency telephone
1-800-424-9300
Icons in SDS
Company Information
company name
XCELUS Building Systems Inc
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
Acute Toxicity (Inhalation) Category 4 Specific Target Organ Toxicity - single exposure: Category 3 (Respiratory system) Respiratory Sensitization: Category 1 Specific Target Organ Toxicity - repeated exposure: Category 1 (Respiratory Tract) Skin Irritation Category 2 Skin sensitization Category 1 Eye Irritation: Category 2B
Signal word
Danger
Hazard statements
Harmful if inhaled. May cause respiratory irritation. May cause allergy, asthma symptoms or breathing difficulties if inhaled. Causes skin irritation. May cause an allergic skin reaction. Causes eye irritation. Causes damage to organs (Respiratory Tract) through prolonged or repeated exposure if inhaled.
Prevention
Avoid breathing dust, mist, gas, vapors or spray. Do not eat, drink or smoke when using this product. Wash skin and face thoroughly after handling. Use only outdoors or in a well-ventilated area. Contaminated work clothing must not be allowed out of the workplace. Wear protective gloves. In case of inadequate ventilation wear respiratory protection. The type of respiratory protection selected must comply with the requirements set forth in OSHA’s Respiratory Protection Standard (29 CFR 1910.134) or regional standards. For additional details, see section 8 of the SDS.
