Note: Ingredients listed on restricted chemical lists
EC/CAS
9002-88-4
Name of the chemical
polyethylene wax
Concentration
50-100
General Information
Revision date
2023-06-12
Product name
Polyethlyene films in various colors
Product Synonyms
IntePlus XF Film, VF Film, Coextruded PE Film, Cross Laminated PE Film, Spiral Cut PE Film,Barrier-Bac VB-250, Barrier-Bac VB-350, Barrier-Bac VB-500, Barrier-Bac VB-600, Barrier-Bac VB-700
1.2.1 Relevant identified uses
of the substance Packaging films or vapor barrier films Restriction(s) on use of the substance
1.2.2. Uses advised against
None known
Emergency telephone
(361) 874- 3737
Icons in SDS
Company Information
company name
World-Pak Division, Inteplast Group Corporation
GHS Information
Signal word
Warning! This product as shipped is not classified as a combustible dust; however, a
Section 2
SECTION 2: Hazards identification
OSHA Hazards Physical Appearance: Films that are natural translucent or in various colors Immediate Concerns: When using or handling IntePlus® Films as supplied, there are very low hazards.
Hazard statements
Categories Not classified
Signal word
Warning! This product as shipped is not classified as a combustible dust; however, a combustible concentration of dust may occur if fine powders accumulated or suspended in an enclosed or confined area (e.g. from cutting or sanding the product).
Hazard pictograms
There is no pictogram for a combustible dust hazard Rough edges of the products could result in minor cuts to hands. Appropriate gloves should be worn to prevent cuts and/or scraps. Avoid contact with strong oxidizing agents When working with the IntePlus® Films at hot temperatures, the material may begin to decompose producing fumes that can contain carbon dioxide, carbon monoxide, and other unidentified organic compounds that come from the breakdown of the materials used to make the films. Adequate ventilation should be provided to minimize exposures to vapors and fumes. When cutting, shaping or modifying IntePlus® Films, other hazards may exist
Potential health effects
Eyes: Dust from cutting may result and mechanically irritate the eyes; if using elevated temperatures, vapors may irritate eyes. Skin: Cuts or scraps referenced above; if using elevated temperatures to soften the IntePlus® Films, Sheet exposure to molten resin may cause thermal burns. Ingestion: May cause choking if swallowed. Inhalation: Inhalation of dust at high concentration may cause irritation of the respiratory system; inhalation of vapors from use of elevated temperatures may also cause irritation of the respiratory system.
