Note: Ingredients listed on restricted chemical lists
EC/CAS
120-55-8
Name of the chemical
DEGDB, Oxydiethylene-dibenzoate
Concentration
≥3-<5
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
≥1-<3
EC/CAS
107-21-1
Name of the chemical
Ethane-1,2-diol
Concentration
≥1-<2
General Information
Version
1.04
Revision date
2015-11-11
Product name
WHITE LIGHTNING SIDINGPro Urethanized Acrylic Sealant White
Manufacturer Name
White Lightning Products
Emergency telephone
(216) 566-2917, (216) 566-2902, (800) 424-9300
Icons in SDS
Company Information
company name
White Lightning Products
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H351, H373
Hazard statements
Code
Statements
H351
Suspected of causing cancer
Section 2
SECTION 2: Hazards identification
Signal word
Warning
Hazard statements
Suspected of causing cancer. May cause damage to organs through prolonged or repeated exposure.
Precautionary statements
General : Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves. Wear eye or face protection. Wear protective clothing. Do not breathe vapor.
Response
Get medical attention if you feel unwell. IF exposed or concerned: Get medical attention.
Storage
Store locked up.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Adequate ventilation required when sanding or abrading the dried film. If Adequate ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. Please refer to the SDS for additional information. Do not transfer contents to other containers for storage.
2.3 Other hazards
None known.
2.1 Classification of the substance or mixture
Classification of the : CARCINOGENICITY - Category 2 substance or mixture SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 2