Note: Ingredients listed on restricted chemical lists
EC/CAS
7440-48-4
Name of the chemical
Cobalt, Metall (2020/217)
Concentration
25-<50%
EC/CAS
7440-47-3
Name of the chemical
Chromium; chromic acid and its salts
Concentration
10-<20%
EC/CAS
7440-02-0
Name of the chemical
Nickel
Concentration
1-<2.5%
General Information
Revision date
2021-09-08
Product name
Weartech WT-800
1.2.1 Relevant identified uses
PAW, Thermal Spray and Laser Clad
1.2.2. Uses advised against
Not known. Read this SDS before using this product
Emergency telephone
+1 (888) 609-1762, +1 (216) 383-8962, +1 (216) 383-8966, +1 (216) 383-8969
Icons in SDS
Company Information
company name
Weartech International, Inc
e-mail address of the competent person responsible for the Safety Data Sheet
sales@weartech.net, EHS@weartech.eu
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
result in GHS classification: Classified according to the criteria of the Globally Harmonized System of Classification and Labeling of Chemicals (GHS), The United States Occupational Safety and Health Administration’s Hazard Communication Standard (29 CFR 1910.1200), Canada’s Hazardous Product Regulations and Mexico’s Harmonized System for the Identification and Communication of Hazards and Risks from Hazardous Chemicals in the Workplace.
Health hazards
Acute toxicity (Oral) Category 4 Acute toxicity (Inhalation - dust and Category 2 mist) Serious Eye Damage/Eye Irritation Category 2B Respiratory sensitizer Category 1 Skin sensitizer Category 1 Carcinogenicity Category 1B Toxic to reproduction Category 2 Specific Target Organ Toxicity - Category 1 Repeated Exposure
Environmental hazards
Acute hazards to the aquatic Category 1 Chronic hazards to the aquatic Category 1
Signal word
Danger
Hazard statements
Fatal if inhaled. Harmful if swallowed. Causes eye irritation. May cause allergy or asthma symptoms or breathing difficulties if inhaled. May cause an allergic skin reaction. May cause cancer. Suspected of damaging fertility. Causes damage to organs respiratory tract through prolonged or repeated exposure. Very toxic to aquatic life with long lasting effects.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapors/spray. Wash face, hands and any exposed skin thoroughly after handling. Do not eat, drink or smoke when using this product. Use only outdoors or in a well-ventilated area. Contaminated work clothing should not be allowed out of the workplace. Avoid release to the environment. Wear protective gloves/protective clothing/eye protection/face protection. Use personal protective equipment as required. [In case of inadequate ventilation] wear respiratory protection.
Response
IF SWALLOWED: Call a POISON CENTER/doctor if you feel unwell. Rinse mouth. IF ON SKIN: Wash with plenty of soap and water. Wash contaminated clothing before reuse. If skin irritation or rash occurs: Get medical advice/attention. Specific treatment (see supplemental first aid instructions on this label). IF INHALED: Remove person to fresh air and keep comfortable for breathing. Immediately call a POISON CENTER/doctor. If experiencing respiratory symptoms IF IN EYES Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. IF exposed or concerned: Get medical advice/attention. Collect spillage.
Storage
Store in a well-ventilated place. Keep container tightly closed. Store locked up.
Disposal
Dispose of contents/ container to an approved facility in accordance with local, regional, national and international regulations. Other hazards which do not Electrical Shock can kill. If welding must be performed in damp locations or result in GHS classification: with wet clothing, on metal structures or when in cramped positions such as sitting, kneeling or lying, or if there is a high risk of unavoidable or accidental contact with work piece, use the following equipment: Semiautomatic DC Welder, DC Manual (Stick) Welder, or AC Welder with Reduced Voltage Control. Arc rays can injure eyes and burn skin. Welding arc and sparks can ignite combustibles and flammable materials. Overexposure to welding fumes and gases can be hazardous. Read and understand the manufacturer’s instructions, Safety Data Sheets and the precautionary labels before using this product. Refer to Section 8. Substance(s) formed under the The welding fume produced from this welding electrode may contain the conditions of use: following constituent(s) and/or their complex metallic oxides as well as solid particles or other constituents from the consumables, base metal, or base metal coating not listed below. Chemical Identity CAS-No. Carbon dioxide 124-38-9 Carbon monoxide 630-08-0 Nitrogen dioxide 10102-44-0 Ozone 10028-15-6