Note: Ingredients listed on restricted chemical lists
EC/CAS
8052-41-3
Name of the chemical
Stoddard Solvent; Naphtha (petroleum), hydrodesulfurized heavy
Concentration
70.0-80.0%
EC/CAS
68476-86-8
Name of the chemical
Petroleum gases, liquefied, sweetened
Concentration
10.0-30.0%
General Information
Revision date
2015-05-27
Product name
Klean-Strip Aerosol Paint Thinner
1.2.1 Relevant identified uses
Paint, stain, and varnish thinning
Icons in SDS
Company Information
company name
W. M. Barr
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
OSHA Flammable Aerosols, Category 1 Gas Under Pressure, Liquefied gas Acute Toxicity: Inhalation, Category 4 Skin Corrosion/Irritation, Category 2 Serious Eye Damage/Eye Irritation, Category 2B Germ Cell Mutagenicity, Category 1A Toxic To Reproduction, Category 2 Specific Target Organ Toxicity (single exposure), Category 3 Aspiration Toxicity, Category 1 Simple Asphyxiant
Signal word
Danger
Hazard statements
H222: Extremely flammable aerosol. H280: Containers gas under pressure; may explode if heated. H304: May be fatal if swallowed and enters airways. H315: Causes skin irritation. H320: Causes eye irritation. H332: Harmful if inhaled. H336: May cause drowsiness or dizziness. H340: May cause genetic defects. H361: Suspected of damaging fertility or the unborn child.
Precautionary statements
P201: Obtain special instructions before use. P202: Do not handle until all safety precautions have been read and understood. P210: Keep away from heat/sparks/open flames/hot surfaces. - No smoking. P211: Do not spray on an open flame or any other ignition source. P251 Pressurized container Do not pierce or burn, even after use P261: Avoid breathing gas/mist/vapors/spray. P264: Wash hands thoroughly after handling. P271: Use only outdoors or in a well-ventilated area. P280: Wear protective gloves/protective clothing/eye protection/face protection. P281: Use personal protective equipment as required.
Response
P301+310 IF SWALLOWED Immediately call a POISON CENTER or doctor/physician P302+352 IF ON SKIN Wash with plenty of soap and water P304+340 IF INHALED Remove victim to fresh air and keep at rest in a position comfortable for breathing. P305+351+338 IF IN EYES Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P308+313 IF exposed or concerned Get medical attention/advice P312: Call a POISON CENTER or doctor/physician if you feel unwell. P321: Specific treatment see label. P331: Do NOT induce vomiting. P332+313: If skin irritation occurs, get medical advice/attention. P337+313: If eye irritation persists, get medical advice/attention. P362: Take off contaminated clothing and wash before re-use.
Storage
P403+233: Store container tightly closed in well-ventilated place. P405: Store locked up. P410+403: Protect from sunlight and store in well-ventilated place. P412: Do not expose to temperatures exceeding 50 ºC/122 ºF. P501: Dispose of contents/container according to local, state and federal regulations. Flammability Instability Hazard Rating System: HEALTH * 1 4 FLAMMABILITY 4 1 0 PHYSICAL 0 Health PPE X HMIS: NFPA: Special Hazard
Potential health effects
Inhalation Acute Exposure Effects: (Acute and Chronic): Breathing high concentrations may be harmful. Mist or vapor can irritate the throats and lungs. Breathing this material may cause central nervous system depression with symptoms including nausea, headache, dizziness, fatigue, drowsiness, or unconsciousness. Intentional misuse of this product by deliberately concentrating and inhaling can be harmful or fatal. Skin Contact Acute Exposure Effects: This product can cause mild, transient skin irritation. The severity of irritation will depend on the amount of material that is applied to the skin and the speed and thoroughness that it is removed. Symptoms include redness, itching, and burning of the skin. Repeated or prolonged skin contact can produce moderate irritation (dermatitis). Eye Contact Acute Exposure Effects: This product can cause transient mild eye irritation with short-term contact with liquid sprays or mists. Symptoms include stinging, watering, redness, and swelling. Ingestion Acute Exposure Effects: If swallowed, this material may irritate the mucous membranes of the mouth, throat, and esophagus. It can be readily absorbed by the stomach and intestinal tract. Symptoms include a burning sensation of the mouth and esophagus, nausea, vomiting, dizziness, staggering gait, drowsiness, loss of consciousness, and delirium, as well as additional central nervous system (CNS) effects. Due to its light viscosity, there is a danger of aspiration into the lungs during vomiting. Aspiration can result in severe lung damage or death. Chronic Exposure Effects: Reports have associated repeated and prolonged overexposure to solvents with irreversible brain and nervous system damage. Effects of ingestion and subsequent aspiration into the lungs may cause pneumatocele (lung cavity) formation and chronic lung dysfunction. Target Organs: May cause damage to the: kidneys, lungs, liver, mucous membranes, upper respiratory tract, skin, central nervous system, eye, lens or cornea.
Principle Routes of Exposure
Inhalation, Skin Absorption Medical Conditions Generally Diseases of the skin, liver, kidneys, central nervous system and respiratory system. Aggravated By Exposure