General Information
Revision date
2024-07-18
Product name
BF 07
Product name
BF 07
Identification on the label/Trade name
FORNACI CALCE GRIGOLIN S.p. A
1.2.1 Relevant identified uses
Premixed for plastering and consolidation
Icons in SDS
Company Information
company name
Via Foscarini, 2
e-mail address of the competent person responsible for the Safety Data Sheet
info@fornacigrigolin.it
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H315, H317, H318, H335
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
The product is classified as hazardous pursuant to the provisions set forth in (EC) Regulation
2.2 Label elements
Hazard labelling pursuant to EC Regulation
Signal word
Danger
Hazard statements
H318 Causes serious eye damage. H315 Causes skin irritation. H335 May cause respiratory irritation. H317 May cause an allergic skin reaction.
Precautionary statements
P101 If medical advice is needed, have product container or label at hand. P102 Keep out of reach of children. P261 Avoid breathing dust. P280 Wear protective gloves / face protection. P302+P352 IF ON SKIN: Wash with plenty of of soap and water. P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P310 Immediately call a POISON CENTER / doctor / . . . P403+P233 Store in a well-ventilated place. Keep container tightly closed.
Contains
PORTLAND CEMENT CLINKER
2.3 Other hazards
On the basis of available data, the product does not contain any PBT or vPvB in percentage ≥ than 0,1%. The product does not contain substances with endocrine disrupting properties in concentration ≥ 0.1%. The mixture has a low chromate content. After adding water the soluble chromium (VI) content is at most 2 ppm on the dry product. To maintain a low chromate content, store it properly, in dry conditions, respecting the maximum expected storage terms. The percentage of respirable crystalline silicon oxide is less than 1%. Therefore the product is not subject to identification. However it is advisable to use respiratory protection.
