Note: Ingredients listed on restricted chemical lists
EC/CAS
64742-95-6
Name of the chemical
Solvent naphtha (petroleum), light aromatic; Low boiling point naphtha — unspecified (A complex combination of hydrocarbons obtained from distillation of aromatic streams. It consists predominantly of aromatic hydrocarbons having carbon numbers predominantly in the range of C8 through C10 and boiling in the range of approximately 135 °C to 210 °C.)
Concentration
5-10
EC/CAS
5625-90-1
Name of the chemical
N,N′-Methylenebismorpholine
Concentration
1-5
EC/CAS
110-91-8
Name of the chemical
Morpholine
Concentration
1-5
EC/CAS
91-20-3
Name of the chemical
Naphthalene,3
Concentration
<1
EC/CAS
98-82-8
Name of the chemical
Cumol (2022/692)
Concentration
<1
General Information
Revision date
2015-07-15
Product name
BioGuard Plus 6
supplier name
ValvTect Petroleum Products A Division of Kop-Coat, Inc
Emergency telephone
+1 703-527-3887, 1-800-424-9300
Icons in SDS
Company Information
company name
ValvTect Petroleum Products A Division of Kop-Coat, Inc
e-mail address of the competent person responsible for the Safety Data Sheet
Valvtect@valvtect.com
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
(29 CFR 1910.1200) Classification of the substance or mixture
Signal word
Danger Hazard Statements Harmful if swallowed Toxic if inhaled Causes skin irritation Causes serious eye irritation May cause an allergic skin reaction Suspected of causing cancer May be fatal if swallowed and enters airways Flammable liquid and vapor Precautionary Statements - Prevention Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Wash face, hands and any exposed skin thoroughly after handling Do not eat, drink or smoke when using this product Avoid breathing dust/fume/gas/mist/vapors/spray Use only outdoors or in a well-ventilated area Contaminated work clothing should not be allowed out of the workplace Keep away from heat/sparks/open flames/hot surfaces. - No smoking Keep container tightly closed Ground/Bond container and receiving equipment Use explosion-proof electrical/ventilating/lighting/equipment Use only non-sparking tools Take precautionary measures against static discharge Keep cool Wear protective gloves/protective clothing/eye protection/face protection Precautionary Statements - Response If exposed or concerned: Get medical advice/attention IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing If eye irritation persists: Get medical advice/attention If skin irritation or rash occurs: Get medical advice/attention IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower Wash contaminated clothing before reuse IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing Call a POISON CENTER or doctor/physician Rinse mouth IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician Do NOT induce vomiting In case of fire: Use CO2, dry chemical, or foam for extinction Precautionary Statements - Storage Store locked up Store in a well-ventilated place. Keep container tightly closed
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
Not Applicable
Further information
Not Applicable Unknown Acute Toxicity < 1% of the mixture consists of ingredient(s) of unknown toxicity
2.1 Classification of the substance or mixture
GHS Classification in accordance with 29 CFR 1910.1200 Acute Toxicity - Oral Category 4 Acute toxicity - Inhalation (Dusts/Mists) Category 3 Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2 Skin sensitization Category 1 Carcinogenicity Category 2 Aspiration toxicity Category 1 Flammable liquids