Note: Ingredients listed on restricted chemical lists
EC/CAS
8052-41-3
Name of the chemical
Stoddard Solvent; Naphtha (petroleum), hydrodesulfurized heavy
Concentration
5-15
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
<5
General Information
Revision date
2015-05-21
Product name
USP 901 Premium Modified Bitumen Adhesive, USP 954 Premium Modified Flashing Cement
Product name
USP 901 Premium Modified Bitumen Adhesive, USP 954 Premium Modified Flashing Cement
Identification on the label/Trade name
USP 901 PREMIUM MODIFIED BITUMEN ADHESIVE, (aka BH5330)
Product Synonyms
Cold Process Adhesive
Chemical name
Asphalt Mixture (Article)
1.2.1 Relevant identified uses
Used as a cold process adhesive for modified bitumen membranes
1.2.2. Uses advised against
For exterior use only. Do not use indoors. Adequate ventilation recommended
supplier name
Toll Manufacturer Location
Emergency telephone
1-800-424-9300
Icons in SDS
Company Information
company name
U.S. PLY, INC
e-mail address of the competent person responsible for the Safety Data Sheet
technical@usply.com, sds@ergon.com
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
Physical hazards
Flammable liquids Category 3
Health hazards
Skin corrosion / irritation Category 2 Serious eye damage/eye irritation Category 2 Germ cell mutagenicity Category 1 Carcinogenicity Category 1 Specific Target organ toxicity, single exposure Category 3 narcotic effects Specific Target organ toxicity, repeated exposure Category 1
Environmental hazards
Not classified
Signal word
Danger
Hazard statements
May cause cancer. Causes damage to organs through prolonged or repeated exposure. May cause genetic defects. Causes serious eye irritation. Flammable liquid and vapor. May cause drowsiness or dizziness. Causes skin irritation.
Prevention
Wear protective gloves/protective clothing/eye protection/face protection. Do not eat, drink or smoke when using this product. Keep away from heat/sparks/open flames/hot surfaces. – No smoking. Keep container tightly closed. Ground/bond container and receiving equipment. Use explosion-proof electrical/ventilating/lighting equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Wash thoroughly after handling. Avoid breathing dust/fume/gas/mist/vapors/spray. Use only outdoors or in a well-ventilated area. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood.
Response
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. If skin irritation occurs, seek medical advice/attention. Specific treatment see Section 4 of this SDS. IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower. In case of fire: Use appropriate media for extinction. IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or doctor/physician if you feel unwell. IF ON SKIN: Wash with plenty of soap and water. Take off contaminated clothing and wash before reuse. IF exposed or concerned: Get medical advice/attention. Get medical advice/attention if you feel unwell.
Storage
Store in a well-ventilated place. Keep container tightly closed. Store locked up. Keep cool.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulations See section 13 of this SDS for disposal instructions.
2.3 Other hazards
None known
Additional information
None