Note: Ingredients listed on restricted chemical lists
EC/CAS
68476-86-8
Name of the chemical
Petroleum gases, liquefied, sweetened
Concentration
1-10
EC/CAS
111-76-2
Name of the chemical
Ethylene glycol monobutyl ether (EGBE)
Concentration
1-10
General Information
Version
1.03
Revision date
2015-06-10
Product name
TEX COAT CHIPGUARD CLEAR
Product Synonyms
None
1.2.1 Relevant identified uses
Chip Guard. For Professional and Industrial Use Only
1.2.2. Uses advised against
Not for sale to the general public
supplier name
Chip Guard. For Professional and Industrial Use Only
Emergency telephone
+1-703-527-3887, 1-800-424-9300
Icons in SDS
Company Information
company name
Transtar Autobody Technologies
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H222, H223, H229, H280, H315, H319, H332, H336, H360
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
Classification Acute toxicity - Inhalation (Dusts/Mists) Category 4 Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Reproductive Toxicity Category 1B Specific target organ toxicity (single exposure) Category 3 Flammable aerosols Category 1 Gases under pressure Compressed Gas
2.2 Label elements
Emergency Overview DANGER
Hazard statements
Harmful if inhaled Causes skin irritation Causes serious eye irritation May damage fertility or the unborn child May cause drowsiness or dizziness Extremely flammable aerosol Contains gas under pressure; may explode if heated Appearance opaque Physical state Aerosol Odor Solvent
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Wear protective gloves/protective clothing/eye protection/face protection Avoid breathing dust/fume/gas/mist/vapors/spray Use only outdoors or in a well-ventilated area Wash face, hands and any exposed skin thoroughly after handling Keep away from heat/sparks/open flames/hot surfaces. — No smoking Do not spray on an open flame or other ignition source Pressurized container: Do not pierce or burn, even after use
Response
If exposed or concerned: Get medical advice/attention Specific treatment (see first aid on this label) IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention Take off contaminated clothing and wash before reuse IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor/physician if you feel unwell
Storage
Store locked up Store in a well-ventilated place. Keep container tightly closed Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
None
Further information
• Harmful to aquatic life with long lasting effects 1.33E-05% of the mixture consists of ingredient(s) of unknown toxicity
2.1 Classification of the substance or mixture
Acute toxicity - Inhalation (Dusts/Mists) Category 4 Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Reproductive Toxicity Category 1B Specific target organ toxicity (single exposure) Category 3 Flammable aerosols Category 1 Gases under pressure Compressed Gas