Note: Ingredients listed on restricted chemical lists
EC/CAS
100-42-5
Name of the chemical
Styrene ( Vinyl benzene )
Concentration
N/A
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
N/A
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
202-851-5
Name of the chemical
Styrol (605/2014)
Concentration
N/A
EC/CAS
238-877-9
Name of the chemical
Talc: Hydrated magnesium silicate
Concentration
N/A
EC/CAS
236-675-5
Name of the chemical
Titandioxid; [in Pulverform mit mindestens 1 % Partikel mit aerodynamischem Durchmesser ≤ 10 μm] (2020/217)
Concentration
N/A
EC/CAS
238-878-4
Name of the chemical
Quarz-A-Staub (s. u. TRGS 906)
Concentration
N/A
General Information
Revision date
2005-10-10
Product name
Kwik Fill Polyester Primer Gray Part A
1.2.1 Relevant identified uses
Primer MSDS Prepared By: Kent Lewis ________________________________________________________________________________
Emergency telephone
Phone(s) 800-424-9300 (CHEMTREC), 613-996-6666 (CANUTEC
Icons in SDS
Company Information
company name
TRANSTAR AUTOBODY TECHNOLOGIES
GHS Information
Signal word
DANGER!
Section 2
SECTION 2: Hazards identification
DANGER! EXTREMELY FLAMMABLE LIQUID AND VAPOR. VAPORS MAY CAUSE FLASH FIRE. CAUSES EYE, SKIN, NOSE AND THROAT IRRITATION. HMIS Hazard Ratings: Health =2*, Flammability =3, Chemical Reactivity =2 Note: HMIS ratings involve data and interpretations that may vary from company to company. They are intended only for rapid, general identification of the magnitude of the specific hazard. To deal adequately with the safe handling of this material, all the information contained in this MSDS must be considered.
Potential health effects
Acute Effects (Short Term): Eye: Contact with liquid or vapor may result in irritation, redness, tearing, and blurred vision. Skin: May cause mild skin irritation. Prolonged or repeated contact may dry the skin. Symptoms may include redness, burning, drying and cracking of skin, and skin burns. Swallowing: Ingestion of this material may cause gastrointestinal irritation, nausea, diarrhea, and vomiting. Aspiration of this material into the lungs due to vomiting may produce chemical pneumonitis which can be fatal. Inhalation: Excessive inhalation of vapors may cause nasal and respiratory irritation, acute nervous system depression, fatigue, weakness, nausea, headache, and dizziness. Symptoms usually occur at air concentrations higher than the recommended exposure limits (See Section 8).
Potential chronic health
of Overexposure (Long Term) Styrene: Excessive overexposure to styrene has been found to cause the following effects in humans and may aggravate pre-existing disorders of these organs; central nervous system effects, effects on hearing, mild effects on color vision and respiratory tract damage. Crystalline Silica: Crystalline silica is considered to be hazardous by inhalation, and is a potential human carcinogen (IARC Group 1). The risk depends on the duration and level of exposure to dust from sanding surfaces or mist from spray applications. Crystalline silica may also produce silicosis, which is a non-cancerous lung disease. Acetone: Overexposure to this material may have effects on the blood and bone marrow.
Cancer information
The International Agency for Research on Cancer (IARC) has classified styrene as a group 2B carcinogen (possibly carcinogenic to humans). This classification is not based on evidence that styrene may be carcinogenic, but rather on a revised definition for Group 2B, and consideration of new data on styrene oxide(Group 2A). The IARC has classified crystalline silica as a group 1 carcinogen (sufficient evidence of carcinogenicity in humans). This material may contain trace amounts of chemicals considered to be carcinogenic by OSHA, (Benzene, IARC-Group 1, Ethylene Oxide, IARC-Group 1 and N-Nitrosodimethylamine, IARC Group-2A).
Other Health Effects
NOTICE Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal.
Principle Routes of Exposure
Inhalation, Skin contact, Eye contact, Ingestion, Skin absorption.