General Information
Product name
FIREFIGHTING PROCEDURES: Minimum equipment to
Icons in SDS
Company Information
company name
This definition page is intended for use with Material Safety Data Sheets supplied by the Ashiand Petroleum Company
Section 2
Hazard statements
assigned by the COMPONENTS National Fire Protection Association. Components are fisted in this section if they present a SECTION V physical or health hazard and are present at or above is identified as a neAL ee HEALTH HAZARD DATA 1% in the mixture. if a component CARCINOGEN by NTP, IARC or OSHA as of the date on For product. PERMISSIBLE EXPOSURE LIMIT: the MSDS, it will be listed and footnoted in this section Nega- when present at or above 0.1% in the product. THRESHOLD LIMIT VALUE: For product. tive conclusions concerning carcinogenicity are not re- Potential local ported. Additional health information may be found in EFFECTS OF ACUTE OVEREXPOSURE: ection V. Components subject to the reporting re- and systemic effects due to single or short term quirements of Section 313 o! SARA Title Ill are identi- overexposure to the eyes and skin or through in- fied in the footnotes in this section, along with typical i halation or ingestion. _ percentages. Other components may be listed deemed appropriate. Potential EFFECTS OF CHRONIC OVEREXPOSURE: local and systemic effects due to repeated or long Exposure recommendations are for components. OSHA term overexposure to the eyes and skin or through Permissible Exposure Limits (PELs) and American Con- inhalation or ingestion. ference of Governmental Industrial Hygienists (ACGIH) Threshold Limit Values (TLVs) appear on the line with Other recommendations FIRST AID: Procedures to be followed when dealing the component identification. with accidental overexposure. appear as footnotes. PRIMARY ROUTE OF ENTRY: Based on properties and SECTION iil expected use. PHYSICAL DATA SECTION Vi - BOILING POINT: Of product if known. The lowest REACTIVITY DATA value of the components is listed for mixtures. HAZARDOUS POLYMERIZATION: Canditions lo avoid VAPOR PRESSURE: Of product if known. The highest to prevent hazardous polymerization resulting in value of the components is listed for mixtures. a large release of energy. SPECIFIC VAPOR DENSITY: Com ared to AIR = 1. If STABILITY: Conditions to avoid to prevent hazardous Specific Vapor Density of pro luct is not known, the or violent decomposition. value is expressed as lighter or heavier than air. INCOMPATIBILITY: Materials and conditions to avoid SPECIFIC GRAVITY: Compared to WATER = 1. If to prevent hazardous reactions. Specific Gravity of product is not known, the value SECTION Vil is expressed as less than or greater than water.