_Tap Mie bo

The StecoCorporation

Revision date : 2023-09-06

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.
GHS07 GHS04 GHS02
Health risk rating 2
Safety risk rating 4
Environmental risk rating 1

Note: Ingredients listed on restricted chemical lists

EC/CAS

202-425-9/95-50-1

Name of the chemical

1,2-dichlorobenzene

Concentration

0-5%

EC/CAS

265-155-0/64742-52-5

Name of the chemical

Distillates (petroleum), hydrotreated heavy naphthenic

Concentration

70-100%

EC/CAS

8052-41-3

Name of the chemical

Stoddard Solvent; Naphtha (petroleum), hydrodesulfurized heavy

Concentration

20-30%

Listed in

General Information

Revision date

2023-09-06

Product name

_Tap Mie bo

Product name

_Tap Mie bo

Identification on the label/Trade name

PP

Manufacturer Name

The StecoCorporation

Emergency telephone

(800)255-3924, +1(813)248-0585

Icons in SDS

GHS02 GHS04 GHS07 M004 M009 M010

Company Information

company name

The StecoCorporation

e-mail address of the competent person responsible for the Safety Data Sheet

steco@tapmagic.com

GHS Information

Signal word

None

Hazard Codes

Hazard statements (CLP)

H222, H229, H280, H319, H336

Hazard statements

Code

Statements

H222

Extremely flammable aerosol

Section 2

SECTION 2: Hazards identification

i i

Signal word

None Danger

Hazard statements

None Extremely flammable aerosol. Contains gas under pressure; may explode if heated. Gauses serious eye irritation. May cause drowsiness or dizziness. May displace oxygen and cause rapid suffocation.

Precautionary statements

None OtherNon-GHS Classification: WHMIS None NFPA/HMIS Health Flammability Personal Protection NFPA SCALE (0-4) Keep away from heat/sparks/open flames/hot surfaces. -No smoking. Do nat spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Wash hands thoroughly after handling. Wear eye proiection/face protection. Avoid breathing dust/fume/gas/mist/vapors/spray. Use only outdoors or in a well-ventilated area. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. If inhaled: Remove person to fresh air and keep comfortable for breathing. Cail a poison center/doctor if you feel unwell, Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F. Store in a well-ventilated place. Store locked up. Dispose of contents/container in accordance with local/regional/national/international Regulations.

HMIS® ratings

(0-4) Ingredients: Reference to other sections: None — BECTION 7: Handling and storage | Precautions for safe handling: Avoid contact with skin, eyes, and clothing. Follow proper disposal methods. Refer to Section 13. Do not eat, drink, smoke, or use personal products when handling chemical substances. Use only with adequate ventilation. Conditions for safe storage, including any incompatibilities: Keep container tightly sealed. Store away from incompatible materials. SECTION 8: Exposure controls/personal protection ControlParameters: No applicable occupational exposure limits. Appropriate Engineering controls: Emergency eye wash fountains and safety showers should be available in the immediate vicinity of use or handling. Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapor and mists below the applicable workplace exposure limits (Occupational Exposure Limits-OELs) indicated above. Respiratory protection: Where risk assessment shows air-purifying respirators are appropriate use a full-face respirator with multipurpose combination (US) or type ABEK (EN 14387) respirator cartridges as a backup to engineering controls. If the respirator is the sole means of protection, use a full-face supplied air respirator. Use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN(EU). Protection of skin: Select glove material impermeable and resistant to the substance. Select glove material based on rates of diffusion and degradation. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Use proper glove removal technique without touching outer surface. Avoid skin contact with used gloves. Contact glove manufacturer for specific information. Wear appropriate clothing to prevent any possibility of skin contact. Eye protection: Safety glasses or goggles are appropriate eye protection. General hygienic measures: Avoid contact with skin, eyes, andclothing. SECTION ‘9: Physical and chemical properties. Appearance. Explosion limit . (physical state,’ Liquid, Amber lower: Explosion Not determined Odor: Mild Vapor:pressure at Not determined bes 20°C: Odorthreshold: Not determined Vapor density: Not determined pH-value: =: Neutral (non-aqueous) |R.elative "density: Not determined Melting/Freezing point: °| Not determined Solubilities: Insoluble in water Boiling . Partition coefficient . point/Boiling range: Not determined (n--octanol/water): Not determined Flash point(closedcup): |>150 C AutolSelf Not determined - ignition Waste disposalrecommendations: Dispose of empty containers as unused product. Product or containers must not be disposed together with household garbage. It is the responsibility of the waste generator to properly characterize all waste materials according to applicable regulatory entities (US 40CFR262. 11). US DOT

UN Number

ADR, ADN, DOT, IMDG, IATA None Limited Quantity Exception: None Bulk: Non Bulk: RQ (ifapplicable}: None RQ (ifapplicable): None Proper shipping Name: None

Hazard categories

None None Packing Group: N/A Packing Group: N/A Marine Pollutant (if applicable): No additional information. Comments: None SECTION 15: Regulatory infor United States (USA)

Product definition

Product name SKD-S2 Aerosol: Product code Not available 1.2. RELEVANT IDENTIFIED USES OF THE SUBSTANCE OR MIXTURE AND USES ADVISED AGAINST Use of the substance/mixture Non-Destructive Testing 1.3. DETAILS OF THE SUPPLIER OF THE SAFETY DATA SHEET Manufacturer Distributor Magnaflux . 155 Harlem Ave. T Glenview, IL 60025 - USA T: 847-657-5300 1.4, EMERGENCY TELEPHONE NUMBER Emergency number CHEMTREC 800-424-9300 21. CLASSIFICATION OF THE SUBSTANCE OR MIXTURE GHS classification Flam. Aerosol Liquefied gas Eye lrrit. 2A STOT SE 3 Simple Asphy LABEL ELEMENTS

Hazard pictograms

GHS02 GHS04 GHS07

2.3 Other hazards

H No additional information available. i 2.4. UNKNOWN ACUTE TOXICITY (GHS) Not applicable.

2.1 Classification of the substance or mixture

Eye lrrit. 2A STOT SE 3 Simple Asphy 2.2. LABEL ELEMENTS GHS labeling Hazard pictograms (GHS)

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.