Shopcoat Primer, Gray

SECTION 2: Hazards identification

HMIS CODES

INHALATION of vapor or spray mist. EYE or SKIN contact with the product, vapor or spray mist. Health | 2° EFFECTS OF OVEREXPOSURE Flammabillty | 3 EYES: Irritation. Reactivity | 0 SKIN: Prolonged or repeated exposure may cause irritation. INHALATION: Imitation of the upper respiratory system. May cause nervous system depression. Extreme overexposure may result in unconsciousness and possibly death. ee aes Overexposure to hazardous ingredients in Section 2 may cause adverse chronic effects to the following organs or systems: ®* the urinary system SIGNS AND SYMPTOMS OF OVEREXPOSURE Headache, dizziness, nausea, and loss of coordination are indications of excessive exposure to vapors or spray mists. Redness and itching or burning sensation may indicate eye or excessive skin exposure.

Medical Conditions Generally Aggravated by Exposure

None generally recognized.

Cancer information

For complete discussion of toxicology data refer to Section 11. EYES: Flush eyes with large amounts of water for 15 minutes. Get medical attention. SKIN: Wash affected area thoroughly with soap and water. Remove contaminated clothing and launder before re-use. INHALATION: | If affected, remove from exposure. Restore breathing. Keep warm and quiet. INGESTION: Do not induce vomiting. Get medical attention immediately. FLASH POINT LEL UEL FLAMMAGILITY CLASSIFICATION 50 °F PMCC 0.9 G7 RED LABEL -—- Flammable, Flash below 100 °F (38 °C) EXTINGUISHING MEDIA Carbon Dioxide, Dry Chemical, Foam UNUSUAL FIRE AND EXPLOSION HAZARDS Closed containers may explode when exposed to extreme heat. Application to hot surfaces requires special precautions. During emergency conditions overexposure to decomposition products may cause a health hazard. Symptoms may not be immediately - apparent. Obtain medical attention. SPECIAL FIRE FIGHTING PROCEDURES Full protective equipment including self-contained breathing apparatus should be used. Water spray may be ineffective. If water is used, fog nozzles are preferable. Water may be used to cool closed containers to prevent pressure build-up and possible autoignition or explosion when exposed to extreme heat. STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED Remove all sources of ignition. Ventilate the area. Remove with inert absorbent. [ rR oT STORAGE CATEGORY DOL Storage Class IB PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE Contents are FLAMMABLE. Keep away from heat, sparks, and open flame. During use and until all vapors are gone: Keep area ventilated - Do not smoke - Extinguish ail flames, pilot lights, and heaters - Turn off stoves, electric tools and appliances, and any other sources of ignition. Consult NFPA Code. Use approved Bonding and Grounding procedures. Keep container closed when not in use. Transfer only to approved containers with complete and appropriate labeling. Do not take internally. Keep out of the reach of children. ~ fey PRECAUTIONS TO BE TAKEN IN USE Use only with adequate ventilation. Avoid contact with skin and eyes. Avoid breathing vapor and spray mist. Wash hands after using. This coating may contain materials classified as nuisance particulates (listed “as Dust” in Section 2) which may be present at hazardous levels only during sanding or abrading of the dried film. if no specific dusts are listed in Section 2, the applicable limits for nuisance dusts are ACGIH TLV 10 mg/m3 (total dust),