POLANE 2.8 T Plus FM PMS428C DARK GRAY ASP

Hazard statements (CLP)

H226, H350, H361d, H373

Code

Statements

H226

Flammable liquid and vapour

SECTION 2: Hazards identification

(29 CFR 1910.1200) OSHAIHCS status

Ingredient(s) with unknown acute toxicity

16.2%

Signal word

Danger

Hazard statements

Flammable liquid and vapor. May cause cancer. Suspected of damaging the unborn child. May cause damage to organs through prolonged or repeated exposure.

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves. Wear eye or face protection. Wear protective clothing. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Use explosion-proof electrical, ventilating, lighting and all material-handling equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Keep container tightly closed. Do not breathe vapor. Revision 13/17/2016 Date of previous issue No previous validation Version 1 1/14

Response

Get medical attention if you feel unwell. IF exposed or concerned Get medical attention. IF ON SKIN (or hair) Take off immediately all contaminated clothing. Rinse skin with water or shower

Storage

Store locked up. Store in a well-ventilated place, Keep cool.

Disposal

Dispose of contents and container in accordance with all local, regional, national and international regulations.

Supplemental label elements

DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Contains solvents which can cause permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents can be harmful or fatal. WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. FOR INDUSTRIAL USE ONLY. Adequate ventilation required when sanding or abrading the dried film. If Adequate ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Fallow respirator manufacturer's directions for respirator use, DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. Please refer to the SDS for additional information. Do not transfer contents to other containers for storage.

2.3 Other hazards

None known.

2.1 Classification of the substance or mixture

CARCINOGENICITY - Category 1A TOXIC TO REPRODUCTION (Unborn child) - Category 2 SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 2 Percentage of the mixture consisting of ingredient(s) of unknown toxicity: 16.2%