Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
≥10-≤25
EC/CAS
1333-86-4
Name of the chemical
Carbon black
Concentration
≤3
EC/CAS
64742-65-0
Name of the chemical
Distillates (petroleum), solvent-dewaxed heavy paraffinic; Base oil — unspecified (A complex combination of hydrocarbons obtained by removal of normal paraffins from a petroleum fraction by solvent crystallisation. It consists predominantly of hydrocarbons having carbon numbers predominantly in the range of C20 through C50 and produces a finished oil with a viscosity of not less than 19 10-6 m2.s-1 at 40 °C.)
Concentration
≤0.3
EC/CAS
50-00-0
Name of the chemical
Formaldehyde
Concentration
<0.1
General Information
Revision date
2023-02-23
Product name
KEM AQUA 1700T Water Reducible Baking Enamel
1.2.1 Relevant identified uses
Paint or paint related material
Manufacturer Name
THE SHERWIN-WILLIAMS COMPANY
Emergency telephone
US / Canada: (800) 424-9300
Icons in SDS
Company Information
company name
THE SHERWIN-WILLIAMS COMPANY
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
29 CFR 1910.1200) OSHA/HCS status : This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200).
2.1 Classification of the substance or mixture
FLAMMABLE LIQUIDS - Category 3 SERIOUS EYE DAMAGE/ EYE IRRITATION - Category 1 CARCINOGENICITY - Category 1A SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 1
Ingredient(s) with unknown acute toxicity
12.9% (oral), 14.7% (dermal), 17.2% (inhalation)
Signal word
Danger
Hazard statements
Flammable liquid and vapor. Causes serious eye damage. May cause cancer. Causes damage to organs through prolonged or repeated exposure.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves, protective clothing and eye or face protection. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Use explosion-proof electrical, ventilating or lighting equipment. Use non-sparking tools. Take action to prevent static discharges. Keep container tightly closed. Do not breathe vapor. Do not eat, drink or smoke when using this product. Wash thoroughly after handling.
Response
IF exposed or concerned Get medical advice or attention. IF ON SKIN (or hair) Take off immediately all contaminated clothing. Rinse skin with water. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor.
Storage
Store locked up. Store in a well-ventilated place. Keep cool.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
WARNING This product contains chemicals known to the State of California to cause elements cancer and birth defects or other reproductive harm. FOR INDUSTRIAL USE ONLY.
Contains
Formaldehyde - a potential cancer hazard. Adequate ventilation required when sanding or abrading the dried film. If Adequate ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. This product contains a Significant New Use Rule (SNUR) Chemical. Do not allow this product to enter drains, sewers, wastewater treatment systems, groundwater, streams, lakes or ponds. See Environmental Data Sheet (EDS) for additional details. Please refer to the SDS for additional information. Keep out of reach of children. Do not transfer contents to other containers for storage.
2.3 Other hazards
None known.