MAINTENANCE POWER

SECTION 2: Hazards identification

HMIS CODES

INHALATION of vapor or spray mist. Health 3 EYE or SKIN contact with the product, vapor or spray mist. Flammability 0 EFFECTS OF OVEREXPOSURE Reactivity 0 EYES: Irritation. SKIN: Prolonged or repeated exposure may cause irritation. INHALATION: Irritation of the upper respiratory system. In a confined area vapors in high concentration may cause headache, nausea or dizziness. Prolonged overexposure to hazardous ingredients in Section 2 may cause adverse chronic effects to the following organs or systems: the liver the urinary system the hematopoietic (blood-forming) system SIGNS AND SYMPTOMS OF OVEREXPOSURE Redness and itching or burning sensation may indicate eye or excessive skin exposure.

Medical Conditions Generally Aggravated by Exposure

None generally recognized.

Cancer information

For complete discussion of toxicology data refer to Section 11. SECTION 4 — FIRST AID MEASURES EYES: Flush eyes with large amounts of water for 15 minutes. Get medical attention. SKIN: Wash affected area thoroughly with soap and water. Remove contaminated clothing and launder before re-use. INHALATION: If affected, remove from exposure. Restore breathing. Keep warm and quiet. INGESTION: Do not induce vomiting. Get medical attention immediately. SECTION 5 — FIRE FIGHTING MEASURES FLASH POINT LEL UEL FLAMMABILITY CLASSIFICATION Not Applicable Not Not Applicable Applicable EXTINGUISHING MEDIA Carbon Dioxide, Dry Chemical, Alcohol Foam UNUSUAL FIRE AND EXPLOSION HAZARDS Closed containers may explode (due to the build-up of pressure) when exposed to extreme heat. During emergency conditions overexposure to decomposition products may cause a health hazard. Symptoms may not be immediately apparent. Obtain medical attention. SPECIAL FIRE FIGHTING PROCEDURES Full protective equipment including self-contained breathing apparatus should be used. Water spray may be ineffective. If water is used, fog nozzles are preferable. Water may be used to cool closed containers to prevent pressure build-up and possible autoignition or explosion when exposed to extreme heat. SECTION 6 — ACCIDENTAL RELEASE MEASURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED Remove all sources of ignition. Ventilate the area. Remove with inert absorbent. SECTION 7 — HANDLING AND STORAGE STORAGE CATEGORY Not Applicable PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE Keep container closed when not in use. Transfer only to approved containers with complete and appropriate labeling. Do not take internally. Keep out of the reach of children. SECTION 8 — EXPOSURE CONTROLS/PERSONAL PROTECTION PRECAUTIONS TO BE TAKEN IN USE Use only with adequate ventilation. Avoid contact with skin and eyes. Avoid breathing vapor and spray mist. Wash hands after using. VENTILATION Local exhaust preferable. General exhaust acceptable if the exposure to materials in Section 2 is maintained below applicable exposure

TOXICOLOGICAL INFORMATION

No data available. SECTION 13 — DISPOSAL CONSIDERATIONS WASTE DISPOSAL METHOD Waste from this product may be hazardous as defined under the Resource Conservation and Recovery Act (RCRA) 40 CFR 261. Waste must be tested for corrosivity to determine the applicable EPA hazardous waste numbers. Incinerate in approved facility. Do not incinerate closed container. Dispose of in accordance with Federal, State/Provincial, and Local regulations regarding pollution. SECTION 14 — TRANSPORT INFORMATION Multi-modal shipping descriptions are provided for informational purposes and do not consider container sizes. The presence of a shipping description for a particular mode of transport (ocean, air, etc.), does not indicate that the product is packaged suitably for that mode of transport. All packaging must be reviewed for suitability prior to shipment, and compliance with the applicable regulations is the sole responsibility of the person offering the product for transport. US Ground (DOT) Not Regulated for Transportation. Canada (TDG) Not Regulated for Transportation. IMO Not Regulated for Transportation. IATA/ICAO Not Regulated for Transportation. SECTION 15 — REGULATORY INFORMATION SARA 313 (40 CFR 372.65C) SUPPLIER NOTIFICATION CAS No. CHEMICAL/COMPOUND % by WT % Element Glycol Ethers

Further information

This product has been classified in accordance with the hazard criteria of the Canadian Controlled Products Regulations (CPR) and the MSDS contains all of the information required by the CPR. The above information pertains to this product as currently formulated, and is based on the information available at this time. Addition of reducers or other additives to this product may substantially alter the composition and hazards of the product. Since conditions of use are outside our control, we make no warranties, express or implied, and assume no liability in connection with any use of this information. Section 1: Identification

Product definition

Maki® Bulk Rodenticide Pellets Other identifier(s): Registration No. 20258 Pest Control Products Act Uses or restrictions: Only to be used by certified pest control operators, farmers and persons authorized in government- approved pest control programs. Manufacturer: Liphatech, Inc. 3600 W. Elm Street, Milwaukee, WI 53209 USA Emergency phone 800-351-1476 Monday - Friday 8 00 am - 4 30 pm (US Central time zone) After hours phone: Human or Animal emergencies: RMPDC at 866-514-9168 Spill emergencies: CHEMTREC at 800-424-9300

Hazard categories

Specific Target Organ Toxicity (Single exposure), Category 2; Specific Target Organ Toxicity (Repeated exposure), Category 2 Warning: May cause damage to blood and reduce the clotting ability of blood if swallowed, inhaled or absorbed through skin. Do not breathe dust. Do not eat, drink or smoke when using this product. Wash hands thoroughly after handling. If exposed or if you feel unwell, call a poison control center or doctor. Dispose of container and contents according to instructions on product label. Store locked up.