DH-1177B-Part

SECTION 2: Hazards identification

Effects of Short Term Exposure Swallowing Unknown Inhalation May cause respiratory irritation. Bye May cause transient eye irritation. May cause mechanical eye ittitation. Skin May cause skin sensitization (allergic reaction). May cause transient skm imitation. Effects of Repeated Overexposure Repeated and prolonged occupational overexposure to crystalline silica may cause silicosis, a progressively disabling lung disease. Preexisting respiratory conditions may be aggravated by exposure to crystalline silica. Sigmficant Laboratory Data With Possible Relevance to Human Health. The Intemational Agency for Research on Cancer considers crystalline silica to have limited evidence of carcinogenicity in humans and suffictent evidence in experimental animals (IARC Group 2A} 4d, First Aid Measures Swallowing None should be needed. Inhalation Remove to fresh air. Get medical attention, Eye Flush eyes with water until relieved. Consult a physician. Skin None should be needed. Notes to Physician Any treatment that might be required for overexposure should be directed at the control of symptoms and the clinical conditions. 3. Fire-Fighting Measures Flammability Class: Material will burn if heated. Flash Point: >480 “F Pensky-Martens Extinguishing Media: Water Fog, Carbon Dioxide, Foam, Dry Chemical. Unusual Fire and Explosion Hazards None known Special Firefighting Procedures: Do not enter confined fire space without proper protective equipment including NIOSH approved self contained breathing apparatus 6. Accidental Release Measures Steps to be taken if material is released or spilled Confine in small area; use absorbent to clean up. Place in container for disposal. Waste Disposal Dispose in accordance with federal, state and local regulations. 7, Handling and Storage

Precautionary statements

To Be Taken In Handling And Storage None likely to be needed. Other Precautions Do not breathe sanding dust 8, Exposure Controls Respiratory Protection If the TLV’s listed in Section 2 are exceeded, use a properly fitted NIOSH/MSHA approved respirator with an appropriate protection factor. Refer to

TOXICOLOGICAL INFORMATION

No information available

ECOLOGICAL INFORMATION

No information available

Disposal

Considerations See Section 6. 14, Transport Information Mode Proper Shipping Name JATA (Air) Nae Adhesives, Not Regulated DOT (HM-181)Dofnestic Surface Adhesives, Not Regulated IMDG Code (Ocean} Adhesives, Not Regulated Note: The assignment of Proper Shipping Names is in part a function of the size of the product container and the transport made. For example, the Proper Shipping Name for a bulk container can differ significantly from the Proper Shipping Name for the same product packaged in a non-bulk container. This can also be true for products shipped via different modes of transportation (i.e. ground, air, ocean). The descriptions provided above are intended to provide some guidance. However, these descriptions may not apply to your package size or mode of shrpment. The U.S. Code of Federal Regulations, 49 CFR — Transportation, regulations, and the policies established by some transporters, require that the shipper properly classify and assign a proper Shipping Name, and label, mark and package the material properly. Therefore, the user of this information is cautioned to consult with applicable regulations, and with qualified advisors prior to repackaging and or reshipment of this or other any product which contains this product. 15. Regulatory Information All ingredients in this product are listed on the US TSCA Inventory Warning This product contains Crystalline silica, a chemical knowh to the State of Califomia to cause cancer 16, Other Information The information accumulated herein is believed to be accurate but is not warranted to be whether originating with the company or not. Recipients are advised to confirm in advance of the need that the information is current, applicable, and suitable to their citcumstances. End of MSPS Last page | 1. Chemical Product and Company Identification Matertal Identity Product Name: DH-1177B-Part 2 Product Number: 56312 Generic ID: Epoxy Adhesive, Part 2 Company The Ruscoe Company 485 Kenmore Blvd. Akron, Ohio 44361 Telephone: 330-253-8148 2. Emergency Telephone: 800-424-9300 (Chemtrec — 24 hours/day) Fax: 330-253-4453 Composition/Information on Ingredients Weight ----Expesure Limits----- Ingredients CAS Number % ACGIB/TLV OSHA/PEL Calcium Carbonate 1317-65-3 40-55 NIA N/A Fatty acids, C18-unsatd., dimers, reaction products with polyethyienepolyamines 68410-23-] 40-50 N/A NiA ‘Triethylentetramine 112-24-3 3-5 N/A 6 mgm? Tris-2,4,6-(dimethylaminomethyl)phenal im 90-72-2 15-2 N/A NiA Synthetic Amorphous Silica 112945-52-5 0.5-1 N/A NiA Bis(dimethylaminomethyl) phenol F1O7AB9.0 0.2-0.3 N/A Crystallme Silica 14808-60-7 9.1-0.3 0.10 mpg/eum 0.10 mp/cum *** All ingredients in this product are listed in the T.S.C.A. inventory. Effects of Short Term Exposure Swallowing Unknown, Inhalation Continued on next page May cause respiratory imitation. Eye May cause severe eye irritation and comeal damage. Skin May cause severe skin irritation. Effects of Repeated Overexposure Repeated and prolonged occupational overexposure to crystalline silica may cause silicosis, a progressively disabling lung disease. Preexisting respiratory conditions may be aggravated by exposure to crystalline silica. Stenificant Laboratory Data With Possible Relevance to Human Health. The International Agency for Research on Cancer considers crystalline silica to have iimited evidence of carcinogenicity in humans and sufficient evidence in experimental animals (IARC Group-2A)