Techspray No-Clean Flux Remover

Hazard statements (CLP)

H222, H229, H280, H315, H319, H351

Code

Statements

H222

Extremely flammable aerosol

SECTION 2: Hazards identification

Ingredient(s) with unknown acute toxicity

1.5%

Signal word

Danger

Hazard statements

Extremely flammable aerosol. Causes serious eye irritation. Causes skin irritation. Suspected of causing cancer. Contains gas under pressure; may explode if heated.

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Use personal protective equipment as required. Wear protective gloves. Wear eye or face protection. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Pressurized container: Do not pierce or burn, even after use. Do not spray on an open flame or other ignition source. Wash hands thoroughly after handling.

Response

IF exposed or concerned Get medical attention. IF ON SKIN Wash with plenty of soap and water. Take off contaminated clothing. Wash contaminated clothing before reuse. If skin irritation occurs Get medical attention. IF IN EYES Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical attention.

Storage

Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F. Store in a well-ventilated place.

Disposal

Dispose of contents and container in accordance with all local, regional, national and international regulations.

2.3 Other hazards

None known.

2.1 Classification of the substance or mixture

SKIN CORROSION/IRRITATION - Category 2 SERIOUS EYE DAMAGE/ EYE IRRITATION - Category 2A CARCINOGENICITY - Category 2 GASES UNDER PRESSURE Compressed gas Percentage of the mixture consisting of ingredient(s) of unknown toxicity: 1.5%