General Information
Revision date
2016-05-07
Product name
Robust Multimørtel
CAS No.
65997-15-1
1.2.1 Relevant identified uses
factory dry mortar of mineral bonding agents to mix with water
1.2.2. Uses advised against
No further relevant information available
Emergency telephone
(+47) 22591300
Icons in SDS
Company Information
company name
Steinhardt AS
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H315, H318
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
CLP CLASSIFICATION
GHS05 corrosion Eye Dam. 1 H318 Causes serious eye damage. GHS07 Skin Irrit. 2 H315 Causes skin irritation.
2.2 Label elements
Labelling according to Regulation (EC) No 1272/2008 The product is classified and labelled according to the CLP regulation.
Hazard pictograms
GHS05
Signal word
Danger
Hazardous Ingredients
Cement, portland, chemicals
Hazard statements
H315 Causes skin irritation. H318 Causes serious eye damage.
Precautionary statements
P101 If medical advice is needed, have product container or label at hand. P102 Keep out of reach of children. P103 Read label before use. P280 Wear protective gloves/protective clothing/eye protection/face protection. P302+P352 IF ON SKIN: Wash with plenty of water. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P315 Get immediate medical advice/attention. P332+P313 If skin irritation occurs: Get medical advice/attention. P362+P364 Take off contaminated clothing and wash it before reuse.
2.3 Other hazards
Dust from the dry mix may cause respiratory irritation. Repeated inhalation of relatively large amounts of dust increases the risk of lung disorders. A highly alkaline solution is produced as soon as the dry preparation comes into contact with water or becomes moist. Due to its high alkalinity, moist mortar can cause irritation to the skin and eyes. Particularly if the mortar is contact with the skin over a longer period (e.g. when kneeling in moist mortar), this alkalinity can cause serious damage to the skin. The mixture is low-chromate, thus there is no risk of sensitization from chromate. In the form finished ready for use after adding water, the content of soluble chrome IV is maximum 0.0002% of the dry mass of the cement contained. Requirement for the effectiveness of the chromate reduction is the correct dry storage and adherence of the maximum storage time.
PBT Substances
Not applicable
vPvB Substances
Not applicable
