Robust Flislim - Lett

Hazard statements (CLP)

H315, H318, H335

Code

Statements

H315

Causes skin irritation

CLP CLASSIFICATION

GHS05 corrosion Eye Dam. 1 H318 Causes serious eye damage. GHS07 Skin Irrit. 2 H315 Causes skin irritation. STOT SE 3 H335 May cause respiratory irritation.

2.2 Label elements

Labelling according to Regulation (EC) No 1272/2008 The product is classified and labelled according to the CLP regulation.

Hazard pictograms

GHS05 GHS07

Signal word

Danger

Hazardous Ingredients

Cement, portland, chemicals

Hazard statements

H315 Causes skin irritation. H318 Causes serious eye damage. H335 May cause respiratory irritation.

Precautionary statements

P101 If medical advice is needed, have product container or label at hand. (Contd. of page 1) P102 Keep out of reach of children. P103 Read label before use. P261 Avoid breathing dust/fume/gas/mist/vapours/spray. P271 Use only outdoors or in a well-ventilated area. P280 Wear protective gloves/protective clothing/eye protection/face protection. P302+P352 IF ON SKIN: Wash with plenty of water. P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P310 Immediately call a POISON CENTER/doctor. P312 Call a POISON CENTER/doctor if you feel unwell. P321 Specific treatment (see on this label). P332+P313 If skin irritation occurs: Get medical advice/attention. P403+P233 Store in a well-ventilated place. Keep container tightly closed. P405 Store locked up. P501 Dispose of contents/container in accordance with local/regional/national/international regulations.

2.3 Other hazards

Dust from the dry mix may cause respiratory irritation. Repeated inhalation of relatively large amounts of dust increases the risk of lung disorders. A highly alkaline solution is produced as soon as the dry preparation comes into contact with water or becomes moist. Due to its high alkalinity, moist mortar can cause irritation to the skin and eyes. Particularly if the mortar is contact with the skin over a longer period (e.g. when kneeling in moist mortar), this alkalinity can cause serious damage to the skin. The mixture is low-chromate, thus there is no risk of sensitization from chromate. In the form finished ready for use after adding water, the content of soluble chrome IV is maximum 0.0002% of the dry mass of the cement contained. Requirement for the effectiveness of the chromate reduction is the correct dry storage and adherence of the maximum storage time.

PBT Substances

Not applicable

vPvB Substances

Not applicable