Polycraft Etch Primer 400g

Hazard statements (CLP)

H222+H229, H315, H319, H336, H402

SECTION 2: Hazards identification

Hazard statements

Aerosols – Category 1 Skin Corrosion/Irritation – Category 2 Serious Eye Damage / Eye Irritation – Category 2A Specific target organ toxicity – Single Exposure (Narcotic Effects) – Category 3 Hazardous to the Aquatic Environment Acute Hazard – Category 3 AU019: May form explosive peroxides AUH044: Risk of explosion if heated under confinement H222+H229: Extremely flammable aerosol. Pressurised container; may burst if heated H315: Causes skin irritation. H319: Causes serious eye irritation H336: May cause drowsiness or dizziness H402: Harmful to aquatic life

ADG classification

Class 2.1 Flammable gases

UN Number

1950, AEROSOLS

Signal word

DANGER

Prevention

P210: Keep away from heat, sparks, open flames and hot surfaces. - No smoking. P211: Do not spray on an open flame or other ignition source. P251 Pressurised container Do not pierce or burn, even after use P271: Use only outdoors or in a well ventilated area. P281: Use personal protective equipment as required.

Response

P305+P351+P338 IF IN EYES Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P312: Call a POISON CENTER/doctor/physician/first aider if you feel unwell P337+P313 If eye irritation persists Get medical advice/attention P302+P352 IF ON SKIN Wash with plenty of soap and water P331: Do NOT induce vomiting.

Storage

P403+P405: Store in a well-ventilated place. Store locked up. P410+P412: Store below 30°C, protect from direct sunlight and do not expose to temperatures exceeding 50°C.

Disposal

P501: If the can cannot be recycled, dispose of contents to an approved waste disposal plant and containers to landfill (see Section 13 of this SDS). .