X-treme Polymeric Sand

SECTION 2: Hazards identification

The most immediate and likely hazards are irritation from dust in the eye. When the product is mixed with water, it may form an alkaline solution, which can cause skin irritation. Dust from the product is irritating to breathe. Prolonged overexposure to dust from the product is harmful to breathe, because it will contain crystalline silica. Applicable hazard statement based on respirable crystalline silica content Danger. May cause cancer from inhaling dust. Causes damage to respiratory system (silicosis) through prolonged or repeated exposure to inhaled dust. May cause damage to renal and immune system through prolonged or repeated exposure. Applicable hazard statement based on and oxides content Danger. Causes serious eye damage Causes skin irritation May cause an allergic skin reaction May cause respiratory irritation

Health hazards

Carcinogen Category 1A Specific target organ toxicity, repeated exposure – Category 1 (lungs), Category 2 (immune system, kidney) Because of the calcium oxide content, it is categorized as a Health Hazard: Serious eye damage/eye irritation - Category 1 Skin irritation – Category 2 Skin sensitizer, hazard category 1 Specific target organ toxicity, single exposure, hazard category 3 (irritation) Applicable Precautionary Statements: Based on crystalline silica content Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dusts Do not eat, drink or smoke when using this product. Wear eye protection If exposed or concerned, or if you feel unwell: Get medical advice. Store locked up. Dispose of contents in accord with local regulations Based on oxides content: Avoid breathing dust. Wear skin and eye protection (water resistant protective gloves. Goggles recommended to prevent any dust in eyes). If on skin, wash with plenty of water. Wash any exposed skin thoroughly after handling material Take off contaminated clothing and wash it before reuse. Contaminated work clothing must not be allowed out of the workplace. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. IF ON SKIN: wash with plenty of water. If skin irritation or rash occurs, get medical attention. Immediately call a doctor if any eye irritation or discomfort develops

HMIS® ratings

Health: 1* Fire: 0 Reactivity: 0 HMIS® is a registered trademark of the National Paint and Coatings Association Section 3: Hazardous Ingredients/Composition Ingredient Typical Percentage* CAS # Coal slag .................................................... 0-96% 68476-96-0 Coal slag consists of: Amorphous silica ........................... 20-48% 7631-86-9 Iron oxide ......................................... 8-21% 1309-37-1 Aluminum oxide ............................... 8-21% 1344-27-1 Calcium oxide .................................... 2-7% 1305-78-8 Potassium oxide ......................... 0.596-2% 12136-45-7 Silica sand (as quartz) .................................... 0-% 14808-60-7 Calcium Oxide…………………………………0-5% 1305-78-8 Calcium Hydroxide……………………………0-5% 1305-62-0 Nonhazardous polymeric dust ................... 1.5-5% *Percentages are in final product. Specific chemical identities and concentrations withheld as trade secret. They are available upon request to health professionals, employees and their designated representatives in accord with 29CFR1910.1200(i).