10X Modification Buffer

SECTION 2: Hazards identification

Emergency Overview: Warning Contains material that causes damage to the following organs: mucus membranes, gastrointestinal tract, skin, eyes, stomach. Contains material that may cause damage to the following organ: Heart

Principle Routes of Exposure

Absorbed through skin. Eye contact. Inhalation. Ingestion Carcinogenic effects: None Mutagenic effects: not available

Teratogenic Effects

not available Avoid contact with skin and clothing. Wash thoroughly after handling.

HMIS® ratings

Health: 2 Flammability: 1 Reactivity: 1

NFPA Ratings

Health: 2 Flammability: 1 Reactivity: 1 Section 5. EXPOSURE CONTROLS/EMPLOYEE PROTECTION Wear chemical-resistant gloves, safety goggles, and protective lab clothing. Safety shower and eye bath required. Wash thoroughly after handling. Section 6. FIRST AID MEASURES Notice to Reader: Get immediate medical attention Eyes: Immediately flush eyes with copious amounts of water for at least 15 minutes (irritant) Skin: Immediately wash skin with soap and copious amounts of water (irritant, permeator) Inhalation: If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult give oxygen Ingestion: If swallowed, wash out mouth with water provided person is conscious. Call a physician immediately. Do not induce vomiting unless directed to do so by medical personnel Other: Wash contaminated clothing before re-use Section 7.FIRE FIGHTING MEASURES Upper Flammable Limit: N/A Lower Flammable Limit: N/A Upper Explosion Limit: N/A Lower Explosion Limit: N/A Flashpoint: N/A Auto ignition Temperature: N/A Fire Extinguishing Media: Small fire: Dry chemical powder Unusual Fire/Explosion Data: Large fire:Water spray, fog or foam Not available – N/A Section 8. ACCIDENTAL RELEASE Wear respirator, chemical safety goggles, rubber boots, and heavy rubber gloves. Sweep up, place in a bag, and hold for waste disposal. Avoid raising dust. Ventilate area and wash spill site after material pickup is complete. Section 9. HANDLING AND STORAGE Store in tightly sealed container at room temperature. Section 10.WASTE DISPOSAL Contact a licensed professional waste disposal service to dispose of this material. Observe all federal, State and local environmental regulations. Section 11.Physical and Chemical Properties Physical state and Appearance Clear, colorless liquid pH 7.0 Melting/Freezing point 800.9 C for sodium chloride Solubility: Partially soluble in cold water Soluble in hot water Soluble in methanol Insoluble in n-octanol

TOXICOLOGICAL INFORMATION

Toxic Effects on Humans: Slightly hazardous in case of eye contact, of ingestion, of inhalation (lung irritant) Special Remarks on Toxicity to Animals: Not available Special Remarks on Chronic Effects on Humans: Not available Special Remarks on Other Toxic Effects on Humans: Not available Solulink, Inc. believes the above information to be accurate, but not necessarily all inclusive, and thus should only be used as a guide in the handling and use of this material. The data in this MSDS relates only to the specific material designated herein and does not relate to use in combination with any other material or in any process. Solulink, Inc. shall not take responsibility for any damage resulting from handling or from contact with the above product. The information in this material safety data sheet meets the requirements of the United States Occupational Safety and