Note: Ingredients listed on restricted chemical lists
General Information
Revision date
2015-06-01
Product name
Fast Setting Joint Compounds
1.2.1 Relevant identified uses
Finishing and repair of dry wall per manufacturer’s recommendations
1.2.2. Uses advised against
Avoid breathing dust, avoid skin contact, use in well ventilated area, interior use only
Emergency telephone
262-628-3840
Icons in SDS
Company Information
company name
Solid Products, Inc
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H350, H373
Hazard statements
Code
Statements
H350
May cause cancer
Section 2
Classification (GHS-US)
Carc. 1A H350 STOT RE 2 H373
2.2 Label elements
GHS-US labeling
Hazard pictograms
GHS08
Signal word
Danger
Hazard statements
H350 - May cause cancer (Inhalation) H373 - May cause damage to organs (lungs) through prolonged or repeat exposure (inhalation)
Precautionary statements
P201 - Obtain special instructions before use P202 - Do not handle until all safety precautions have been read and understood P260 - Do not breathe dust P280 - Wear appropriate personal protective equipment P308+P313 - IF exposed or concerned: Get medical advice/attention P314 - Get medical advice and attention if you feel unwell P501 - Dispose of contents/container to comply with local/regional/national international regulations Store in a cool, dry place away from direct sunlight or excessive heat.
Other hazards which do not result in classification
Other constituents in this product are considered nuisance particles or dust. Exposure to dusts or powders may cause mechanical irritation of the respiratory system, eyes, and skin. . Particulates Not Otherwise Regulated (Respirable Fraction) has an OSHA PEL of 5 mg/m3 (15 mppcf) TWA and ACGIH Guideline of 3 mg/m3 TWA. Particulates Not Otherwise Regulated (Total Dust) has an OSHA PEL of 15 mg/m3 (50 mppcf) TWA and ACGIH Guideline of 10 mg/m3 TWA. 2.4.
Ingredient(s) with unknown acute toxicity
No data available
