SET-XP (SET-XP10, SET-XP22, SET-XP56, SET-XP650, SET-XP)

Hazard statements (CLP)

H315, H317, H319, H341, H350, H373, H411

Code

Statements

H315

Causes skin irritation

SECTION 2: Hazards identification

General Information SET-XP Anchoring Adhesive is a two part system. The two parts of this product have been assessed according to GHS and are classified below. The final hardened material is considered nonhazardous. Some hazards apply upon grinding or cutting through hardened product. Resin (white side) GHS Classification

Physical hazards

Not Classified Not Classified

Health hazards

Skin Corrosion/Irritation Category 2 Serious Eye Damage/Irritation Category 2A Sensitization, Skin Category 1 Germ Cell Mutagenicity Category 2 Skin Corrosion/Irritation Category 1 Serious Eye Damage/Irritation Category 1 Sensitization, Skin Category 1 Germ Cell Mutagenicity Category 2 Carcinogenicity Category 1A STOT, Repeated Exposure Category 2 (Lung)

Environmental hazards

Chronic Aquatic Environmental Hazard Category 2 Acute Aquatic Environmental Hazard Category 3 Chronic Aquatic Environmental Hazard Category 3

Signal word

WARNING! DANGER!

Hazard statements

Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction. Suspected of causing genetic defects. Toxic to aquatic life with long lasting effects. Causes severe skin burns and eye damage. May cause an allergic skin reaction. Suspected of causing genetic defects. Harmful to the aquatic environment with long lasting effects. May cause cancer. May cause damage to organs (Lung) through prolonged or repeated exposure.

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves/protective clothing/eye protection/face protection. Contaminated work clothing should not be allowed out of the workplace. Avoid breathing mist or vapor. Wash thoroughly after handling. Avoid release to the environment. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Use only outdoors or in a well-ventilated area. Contaminated work clothing must not be allowed out of the workplace. Wear protective gloves/protective clothing/eye protection/face protection. In case of inadequate ventilation wear respiratory protection. Avoid release to the environment.

Response

If exposed or concerned Call a poison center/doctor. If on skin Wash with plenty of water. If skin irritation or rash occurs: Get medical advice/attention. Take off contaminated clothing and wash before re-use. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Collect Spillage. If exposed or concerned Get medical advice/attention. If swallowed Rinse mouth. Do not induce vomiting. If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. Wash contaminated clothing before reuse. If skin irritation or rash occurs: Get medical advice/attention. If inhaled: Remove person to fresh air and keep comfortable for breathing. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a poison center/doctor.

Storage

Store locked up. Store in a well-ventilated place. Store between 45-90°F (7-32°C). Store in a well-ventilated place. Keep container tightly closed. Store between 45-90°F (7-32°C).

Disposal

Dispose of contents/container in accordance with local/regional/national regulations. Hardener (green side) GHS Classification Dispose of contents/container in accordance with local/regional/national/international regulations.

2.3 Other hazards

The above hazards are for the uncured Resin component of SET-XP. Upon combination with the Hardener component of SET-XP an innocuous solid is formed which does not present any immediate hazards. Upon grinding or cutting the cured product the following hazards may apply.

Precautionary statements

Do not breathe dust.

2.1 Classification of the substance or mixture

Not Classified. Health Hazards: Skin Corrosion/Irritation Category 2 Serious Eye Damage/Irritation Category 2A Sensitization, Skin Category 1 Germ Cell Mutagenicity Category 2 Environmental Hazards: Chronic Aquatic Environmental Hazard Category 2 Signal Word: WARNING! Hazard Statements: Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction. Suspected of causing genetic defects. Toxic to aquatic life with long lasting effects.