AT (AT10, AT13, AT30, AT)

SECTION 2: Hazards identification

GHS Classification General Information AT Anchoring Adhesive is a two part system. The two parts of this product have been assessed according to GHS and are classified below. The final hardened material is considered nonhazardous. Some hazards apply upon grinding or cutting through hardened product, see Hazards Not Otherwise Classified. Resin (white side) GHS Classification

Physical hazards

Flammable Liquids Category 2 Organic Peroxides Type E

Health hazards

Skin Corrosion/Irritation Category 2 Serious Eye Damage/Irritation Category 2A Sensitization, Skin Category 1 Serious Eye Damage/Irritation Category 2A Sensitization, Skin Category 1 Carcinogenicity Category 1A STOT, Repeated Exposure Category 2A (Lung)

Environmental hazards

Acute Aquatic Environmental Hazard Category 3 Acute Aquatic Environmental Hazard Category 1 Chronic Aquatic Environmental Hazard Category 1

Signal word

DANGER! DANGER!

Hazard statements

Highly flammable liquid and vapor. Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation. Harmful to aquatic life. Heating may cause a fire. Causes serious eye irritation. May cause an allergic skin reaction. Very toxic to aquatic life with long lasting effects. May cause cancer. May cause damage to organs through prolonged or repeated exposure.

Prevention

Keep away from heat/sparks/open flames/hot surfaces. No smoking. Keep container tightly closed. Ground/bond container and receiving equipment. Use explosion-proof electrical/ventilating/lighting equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves/protective clothing/eye protection/face protection. Use only outdoors or in a well-ventilated area. Wash thoroughly after handling. Contaminated work clothing must not be allowed out of the workplace. Avoid release to the environment Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Keep away from clothing and other combustible materials. Wear protective gloves/protective clothing/eye protection/face protection. Do not breathe dust/fume/gas/mist/vapors/spray. Wash thoroughly after handling. Contaminated work clothing must not be allowed out of the workplace. Keep only in original container. Avoid release to the environment.

Response

Response in case of fire: Use alcohol-resistant foam, carbon dioxide, dry powder or water fog for extinction. If exposed or concerned Get medical advice/attention. If in eyes Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists Get medical advice/attention. If on skin Take off immediately all contaminated clothing. Rinse skin with water/shower. If skin irritation or rash occurs: Get medical advice/attention. Wash contaminated clothing before reuse. If exposed or concerned Get medical advice/attention. If in eyes Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists Get medical advice/attention. If on skin Wash with plenty of water. If skin irritation or rash occurs: Get medical advice/attention. Wash contaminated clothing before reuse. Collect spillage.

Storage

Store away from other materials. Store in a well-ventilated place. Keep container tightly closed. Store between 32-80°F (0-27°C). Store locked up. Store away from other materials. Store between 32-80°F (0-27°C). Store locked up.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations. Initiator (black side) GHS Classification Dispose of contents/container in accordance with local/regional/national regulations.

2.3 Other hazards

The above hazards are for the uncured components of AT. Upon combination the two parts form an innocuous solid which does not present any immediate hazards. Upon grinding or cutting through the cured product, the following hazards may apply.

Precautionary statements

Do not breathe dust.