PERI-BOND (PB-3)

SECTION 2: Hazards identification

29 CFR 1910.1200) OSHA/HCS Status: This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200).

2.1 Classification of the substance or mixture

CARCINOGENICITY - Category 1A Percentage of the mixture consisting of ingredient(s) of unknown toxicity: 72.5%

Physical hazards

Not classified 0 Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or risks Although HMIS® ratings are not required on MSDSs under 29 CFR 1910.1200, the preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS® program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA). HMIS® materials may be purchased exclusively from J. J. Keller (800) 327-6868.

Signal word

Danger

Hazard statements

May cause eye/lung/ skin irritation. May cause Cancer. May cause genetic defects. May cause damage to organs through prolonged exposure. Precautionary Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves /

Prevention

protective clothing / eye protection / face protection. Wash well after handling. Contaminated work clothing should not be allowed out of work place.

Response

SKIN: Wash with plenty of soap and water. If skin irritation or rash occurs: Get medical attention / advice. Get medical attention / advice if you feel unwell. EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritant persists get medical attention / advice. If exposed or concerned: get medical attention or advice. Take off contaminated clothing and wash it before reuse.

Storage

Store locked up.

Disposal

Disposal of contents / container in accordance with local / regional /state / federal and international regulations. Hazard(S) not Otherwise None known.

Additional information

Sanding and grinding dusts may be harmful if inhaled. This product contains Crystalline Silica which can cause lung cancer or silicosis. The risk of cancer Substance(s) formed depends on the duration and level of exposure to dust from sanding surfaces under the conditions of or mist from spray applications. Since this product is not meant to be sanded or sprayed, risk of exposure is considered low. Avoid contact with skin and clothing. use: Wash thoroughly after handling. Emits toxic fumes when heated.

Potential chronic health

Health: 2* Flammability: 1