Note: Ingredients listed on restricted chemical lists
EC/CAS
122-20-3
Name of the chemical
1,1',1"-nitrilotripropan-2-ol
Concentration
>=10-<20
EC/CAS
111-42-2
Name of the chemical
N,N-Diethanolamine (Ethanol, 2,2'-iminobis-)
Concentration
>=3-<5
General Information
Revision date
2018-04-27
Product name
SikaGrind -721
1.2.1 Relevant identified uses
For further information, refer to product data sheet
Icons in SDS
Company Information
company name
Sika Canada Inc
e-mail address of the competent person responsible for the Safety Data Sheet
ehs@ca.sika.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H318, H351, H373
Hazard statements
Code
Statements
H318
Causes serious eye damage
Section 2
2.1 Classification of the substance or mixture
Serious eye damage : Category 1 Carcinogenicity : Category 2 Specific target organ system- : Category 2 ic toxicity - repeated expo- sure (Oral)
Signal word
Danger
Hazard statements
H318 Causes serious eye damage. H351 Suspected of causing cancer. H373 May cause damage to organs through prolonged or re- peated exposure if swallowed.
Prevention
P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P260 Do not breathe dust/ fume/ gas/ mist/ vapors/ spray. P280 Wear protective gloves/ protective clothing/ eye protection/ face protection.
Response
P305 + P351 + P338 + P310 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER/doctor. P308 + P313 IF exposed or concerned: Get medical advice/ attention.
Storage
P405 Store locked up.
Disposal
P501 Dispose of contents/ container to an approved waste dis- posal plant.
2.3 Other hazards
None known.
Additional information
If product is in liquid or paste form, physical or health hazards listed related to dust are not con- sidered significant. However, product may contain substances that could be potential hazards if caused to become airborne due to grinding, sanding or other abrasive processes.
