Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
126-30-7
Name of the chemical
2,2-dimethyl-1,3-propanediol
Concentration
N/A
EC/CAS
7632-00-0
Name of the chemical
Sodium nitrite
Concentration
N/A
General Information
Revision date
2016-11-30
Product name
Sikafloor Marine VEM
1.2.1 Relevant identified uses
For further information, refer to product data sheet
Icons in SDS
Company Information
company name
Sika Canada Inc
e-mail address of the competent person responsible for the Safety Data Sheet
ehs@ca.sika.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H318, H350i, H372
Hazard statements
Code
Statements
H318
Causes serious eye damage
Section 2
2.1 Classification of the substance or mixture
Serious eye damage : Category 1 Carcinogenicity (Inhalation) : Category 1A Specific target organ system- : Category 1 (Lungs) ic toxicity - repeated expo- sure
Signal word
Danger
Hazard statements
H318 Causes serious eye damage. H350i May cause cancer by inhalation. H372 Causes damage to organs (Lungs) through prolonged or repeated exposure.
Prevention
P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P260 Do not breathe dust/ fume/ gas/ mist/ vapors/ spray. P264 Wash skin thoroughly after handling. P270 Do not eat, drink or smoke when using this product. P280 Wear protective gloves/ protective clothing/ eye protection/ face protection.
Response
P305 + P351 + P338 + P310 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER/doctor. P308 + P313 IF exposed or concerned: Get medical advice/ attention.
Storage
P405 Store locked up.
Disposal
P501 Dispose of contents/ container to an approved waste dis- posal plant.
2.3 Other hazards
None known.
Additional information
If product is in liquid or paste form, physical or health hazards listed related to dust are not con- sidered significant. However, product may contain substances that could be potential hazards if caused to become airborne due to grinding, sanding or other abrasive processes.
