Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
112-34-5
Name of the chemical
2-(2-butoxyethoxy)ethanol
Concentration
N/A
EC/CAS
68855-54-9
Name of the chemical
diatomaceous earth, soda ash flux-calcined
Concentration
N/A
EC/CAS
64741-89-5
Name of the chemical
Distillates (petroleum), solvent-refined light paraffinic, if they contain > 3 % w/w DMSO extract
Concentration
N/A
EC/CAS
14464-46-1
Name of the chemical
Cristobalit (s. u. TRGS 906)
Concentration
N/A
General Information
Revision date
2021-04-15
Product name
METALATEX Semi-Gloss Acrylic Coating
1.2.1 Relevant identified uses
Paint or paint related material
Manufacturer Name
THE SHERWIN-WILLIAMS COMPANY
Icons in SDS
Company Information
company name
Sherwin-Williams Canada Inc
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
CARCINOGENICITY - Category 1A SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 2
Ingredient(s) with unknown acute toxicity
toxicity: 1.3%
Signal word
Danger
Hazard statements
May cause cancer. May cause damage to organs through prolonged or repeated exposure.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves, protective clothing and eye or face protection. Do not breathe vapor.
Response
IF exposed or concerned: Get medical advice or attention.
Storage
Store locked up.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
WARNING This product contains chemicals known to the State of California to cause elements cancer and birth defects or other reproductive harm. FOR INDUSTRIAL USE ONLY. Adequate ventilation required when sanding or abrading the dried film. If Adequate ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. Please refer to the SDS for additional information. Keep out of reach of children. Do not transfer contents to other containers for storage.
2.3 Other hazards
None known.
