Combat Boron Nitride Coatings

SECTION 2: Hazards identification

OSHA Classification of the substance or mixture

Hazard pictograms

Not Regulated

Signal word

Not Regulated

Hazard statements

Not Regulated

Precautionary statements

Not Regulated - Additional information: Safety data sheet available on request. ‘2.3 Other hazards There are no other hazards not otherwise classified that have been identified. - Results of PBT and vPvB assessment - PBT: Not applicable. - vPvB: Not applicable. - SECTION 3: Composition/informatio - 3.2 Mixtures - Components: CAS: 10043-11-5 boron nitride 4-35% EINECS: 233-136-6 Reg.nr.: 01-2119947399-20-0003. CAS: 1344-28-1 aluminium oxide 0-15% EINECS: 215-691-6 substance with a Community workplace exposure limit Reg.nr.: 01-2119529248-35-XXXX - Additional information: For the wording of the listed Hazard Statements refer to section 16. For the listed ingredient(s), the identity and/or exact percentages are being withheld as a trade secret. __ SECTION 4: First aid measures: ' 4.1 Description of first aid measures - After inhalation: Supply fresh air; consult doctor in case of complaints. - After skin contact: immediately rinse with water. If skin irritation is experienced, consult a doctor. - After eye contact: Remove contact lenses if worn, if possible. Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor. - After swallowing: Rinse out mouth and then drink plenty of water. Do not induce vomiting; call for medical help immediately. - 4.2 Most important symptoms and effects, both acute and delayed Slight irritant effect on skin and mucous membranes. Slight irritant effect on eyes. May cause gastro-intestinal irritation if ingested. Nausea in case of ingestion. Diarrhea. Vomiting. (Cont'd. from page 2) 4.3 Indication of any immediate medical attention and special treatment needed No further relevant information available. - 5.1 Extinguishing media - Suitable extinguishing agents: The product is not flammable. Use fire extinguishing methods suitable to surrounding conditions. - For safety reasons unsuitable extinguishing agents: None. - §.2 Special hazards arising from the substance or mixture No further relevant information available. 5.3 Advice for firefighters ‘ Protective equipment: Wear self-contained respiratory protective device. Wear fully protective suit. ‘6.1 Personal precautions, protective equipment and emergency procedures Ensure adequate ventilation Use personal protective equipment as required. ‘6.2 Environmental precautions Avoid release to the environment. ‘6.3 Methods and material for containment and cleaning up Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Send for recovery or disposal in suitable receptacles. ‘6.4 Reference to other sections See Section 7 for information on safe handling. ; See Section 8 for information on personal protection equipment. See Section 13 for disposal information. = _SECTION.7: Handling and storage ‘7.1 Precautions for safe handling Use only in well ventilated areas. Avoid splashes or spray in enclosed areas. Avoid breathing mist/vapours/spray. Wash hands before breaks and at the end of work. - Information about fire - and explosion protection: No special measures required. -7.2 Conditions for safe storage, including any incompatibilities Storage: - Requirements to be met by storerooms and receptacles: Store in cool, dry conditions in well sealed receptacles. Use only receptacles specifically permitted for this substance/product. - Information about storage in one common storage facility: (Cont'd. from page 3) Store away from foodstuffs. Do not store together with alkalis (caustic solutions). - 7.3 Specific end use(s) No further relevant information available. SECTION 8: Exposure controls/personal protection -8.1 Control parameters ‘ Ingredients with limit values that require monitoring at the workplace: 1344-28-1 aluminium oxide WEL (Great Britain) |Long-term value: 10* 4** mg/m? *inhalable dust **respirable dust PEL (USA) Long-term value: 15*; 5** mg/m* *Total dust; ** Respirable fraction REL (USA) Long-term value: 10* 5** mg/m° as Al*Total dust**Respirable/pyro powd./welding f. TLV (USA) Long-term value: 1* mg/m* as Al; *as respirable fraction - DNELs: No further relevant information available. - PNECs: No further relevant information available. 8.2 Exposure controls - Personal protective equipment: - General protective and hygienic measures: The usual precautionary measures are to be adhered to when handling chemicals. Keep away from foodstuffs, beverages and feed. Avoid breathing mist/vapours/spray. Avoid contact with the eyes. Avoid close or long term contact with the skin. - Respiratory protection: Not required under normal conditions of use. Use suitable respiratory protective device when aerosol or mist is formed. For large spills, respiratory protection may be advisable. ‘Protection of hands: Gloves are advised for repeated or prolonged contact. Wear protective gloves to handle contents of damaged or leaking units. - Eye protection: Safety glasses - Body protection: Not required under normal conditions of use. Protection may be required for spills. - Limitation and supervision of exposure into the environment: Avoid release to the environment. - Risk management measures: No further relevant information available. (Cont'd. from page 4) SECTION 9: Physical and chemical-properties = - 9.1 Information on basic physical and chemical properties - Appearance Form: Liquid Colour: White * Odour: Odourless ‘ Odour threshold: Not determined. - pH-value: 4,.5-9 ‘ Melting point/freezing point: Not determined. ‘ Initial boiling point and boiling range: 100 °C (212 °F) (water) - Flash point

2.1 Classification of the substance or mixture

- Classification according to Regulation (EC) No 1272/2008 The product is not classified as hazardous according to OSHA GHS regulations within the United States. The product is not classified as hazardous according to the CLP regulation.