NEW COAT HIGH TEMP PAINT

SECTION 2: Hazards identification

AUSTRALIA • This material is classified as hazardous according to GHS criteria of Safe Work Australia. • This product is classified as Dangerous Goods according to the Australian Dangerous Goods (ADG) Code. • This product is classified as a Scheduled 5 Poison according to the SUSMP.

Hazard categories

Flammable Liquid - 3 Specific target organ toxicity (Single exposure) – 3 Skin sensitization – 1A 3.1C Flammable liquid - medium hazard; 6.5B Substances that are contact sensitisers; 6.1E Substances that are acutely toxic – May be harmful,

Signal word

WARNING

Hazard statements

Flammable liquid and vapour. May be harmful if swallowed. May cause an allergic skin reaction. May cause drowsiness or dizziness. May cause respiratory irritation.

Precautionary statements

Keep out of reach of children. Read label before use.

Prevention

Keep away from heat, sparks, open flames, hot surfaces – No smoking. Keep container tightly closed. Ground container and receiving equipment. Use explosion-proof equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Avoid breathing mist/vapours/spray. Use only outdoors or in a well-ventilated area. Wear protective clothing, gloves, eye/face protection and suitable respirator as required.

Response

IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or doctor if you feel unwell. IF ON SKIN (or hair): Remove immediately all contaminated clothing. Wash with plenty of soap and water. Call a POISON CENTRE or doctor if you feel unwell. Wash contaminated clothing before reuse. If skin irritation occurs get medical attention. If medical advice is needed have product container or label on hand. In case of fire: Use alcohol resistant foam for extinction. Collect spillage.

Storage

Store in a well-ventilated place. Keep cool. Keep container tightly closed. Store locked up.

Disposal

Dispose of contents/container in accordance with local regulations. NEW ZEALAND • This material is classified as hazardous according to criteria of the New Zealand EPA • Group Standard: Surface Coating and courants (Flammable, Acutely Toxic) • HSNO: HSR002667

UN Number

1263

ADG classification

3 ADG Subsidiary Shipping Name PAINT Risk none allocated Hazchem Code ⚫3YE Packing Group III

SUSMP Classification

S5 CAUTION EMERGENCY OVERVIEW Colour Black Odour Solvent Physical Description liquid Viscosity Viscous

Health hazards

None known SECTION 3 – INGREDIENTS Ingredients determined not to be hazardous are present in concentrations that do not exceed the relevant cut-off concentrations as found from SAFE WORK AUSTRALIA publication “List of Designated Hazardous Substances” or have been found NOT to meet the criteria of a hazardous substance as defined in the SAFE WORK AUSTRALIA publication “Approved Criteria for Classifying Hazardous Substances”. Ingredients: CAS Number: Proportion Exposure (% w/w): Standards TWA STEL Alkyd resin Various 10 - 30 not set Mineral turpentine 64742-88-7 30 - 40 90 ppm not set Methyl Ethyl 96-29-7 < 1 not set Ketoxime Aluminium Powder 7429-90-5 <1 not set The TWA exposure value is the Time Weighted Average airborne concentration of a particular substance when calculated over a normal 8 hour working day for a 5 day working week. The STEL (Short Term Exposure Limit) is an exposure value that should not be exceeded for more than 15 minutes and should not be repeated for more than 4 times per day. There should be at least 60 minutes between successive exposures at the STEL. The term “peak” is used when the TWA limit, because of the rapid action of the substance, should never be exceeded, even briefly.