Multi‐Vent Nailable Base‐3

Hazard statements (CLP)

H317, H320, H334, H335, H350, H360

Code

Statements

H317

May cause an allergic skin reaction

OSHA HCS Classification

Combustible dust Eye irritation Category 2B Respiratory sensitization Category 1 Skin sensitization Category 1 Carcinogenicity (Inhalation) Category 1A Reproductive toxicity Category 1B Specific target organ toxicity Category 3 (Respiratory system) - single exposure

Signal word

Danger

Hazard statements

May form combustible dust concentrations in air. H317 May cause an allergic skin reaction. H320 Causes eye irritation. H334 May cause allergy or asthma symptoms or breathing diffi- culties if inhaled. H335 May cause respiratory irritation. H350 May cause cancer by inhalation. H360 May damage fertility or the unborn child.

Prevention

P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P261 Avoid breathing dust/ fume/ gas/ mist/ vapors/ spray. P264 Wash skin thoroughly after handling. P271 Use only outdoors or in a well-ventilated area. P272 Contaminated work clothing must not be allowed out of the workplace. P280 Wear protective gloves/ protective clothing/ eye protection/ face protection. P284 Wear respiratory protection.

Response

P302 + P352 IF ON SKIN: Wash with plenty of soap and water. P304 + P340 + P312 IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER/doctor if you feel unwell. P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P308 + P313 IF exposed or concerned: Get medical advice/ attention. P333 + P313 If skin irritation or rash occurs: Get medical advice/ attention. P337 + P313 If eye irritation persists: Get medical advice/ atten- tion. P362 + P364 Take off contaminated clothing and wash it before reuse.

Storage

P403 + P233 Store in a well-ventilated place. Keep container tightly closed. P405 Store locked up.

Disposal

P501 Dispose of contents/ container to an approved waste dis- posal plant.

Additional information

There are no ingredients with unknown acute toxicity used in a mixture at a concentration >= 1%.

2.3 Other hazards

No unusual conditions are expected from this product. Freshly expanded or heated foam may off-gas some pentane-blowing agent, which is heavier than air and may accumulate to ignitable concentra- tions if stored inside a sealed container or within confined areas. Ignitable atmospheres have concen- trations that exceed inhalation exposure limits for workers, further reinforcing the need for ventilation when foam is freshly expanded. May form combustible dust concentrations in the air when the product is cut, sanded, sawed, ma- chined or ground. INHALATION HEALTH HAZARDS: Dust may cause transient mechanical irritation of the upper res- piratory tract. Workplace exposures to residual pentane vapors from this product are expected to be below levels of any health risk. Overexposure to high concentrations of pentane can cause narcotic effects. Signs and symptoms of overexposure to pentane include headache, nausea, dizziness, diffi- culty walking, or sleepiness. Studies have shown that short-term (10-minute) exposures to pentane concentrations as high as 5,000 ppm (11,750 mg/m3) produced no symptoms. Workplace exposure limits for pentane and foam dust are listed in Section 8 of this SDS. There is no evidence that dusts generated from this product cause chronic disease in humans. The facer material is not expected to generate dust. No chronic effects are known for exposures to pentane vapor. EYE CONTACT HEALTH HAZARDS: Mechanical irritation, redness, tearing, and blurred vision can occur if dusts generated from these products come into contact with eyes. SKIN CONTACT HEALTH HAZARDS: Direct contact with rough-cut foam can cause mechanical abrasion cuts or puncture to fingers, hands or exposed skin