5 Solvent-free Epoxy Adhesive, Part “A”

Appearance/Odor

Off-white thin paste, mild epoxy-resin odor. Evaporation Rate (butyl acetate =1): Not determined V.O.C. zero % Solids: 97% IV. Fire and Explosion Hazards Flash Point (Method Used): > 400 F Flammable Limits: Not determined Flammability Classification: OSHA: None DOT: Not regulated Extinguishing Media: Carbon dioxide, Dry chemical or foam. Special Fire Fighting Procedures: Water spray may be ineffective. Water may be used to cool closed containers to prevent pressure buildup and possible auto-ignition or explosion when exposed to extreme heat. Fog nozzles are preferred if water is used. Unusual Fire and Explosion Hazards: Keep containers closed except when in use. Closed containers may explode when exposed to extreme heat. Do not use in vicinity of open flame or sparks. Extinguish all pilot lights and all sources of ignition. V. Reactivity Data Stability: Stable Conditions to Avoid: Heat and open flame Incompatibility (Materials to Avoid): Oxidizing materials Hazardous Decomposition Products: Thermal decomposition may produce carbon monoxide and carbon dioxide, as well as organic compounds of unknown structure. Hazardous Polymerization: Will not occur. VI. Health Hazard Data Effects of Exposure: Chronic: Prolonged or repeated skin exposure can cause mild skin irritation or allergic reaction. Acute: Prolonged or repeated skin exposure can cause mild skin irritation. Mildly irritating to the eyes. Emergency and First Aid Procedures: Eyes Flush with water for 15 minutes. Get medical attention if irritation persists. Skin Wash with soap and water or waterless skin cleanser followed by soap and water. Remove contaminated clothing. Get medical help if irritation persists. Ingestion: Seek medical attention. Inhalation: Remove the victim to fresh air. Give artificial respiration if not breathing. Get medical attention. VII. Precautions for Safe Handling and Use Steps to be taken in case material is Scrape into containers for disposal. spilled or released: Waste disposal method: Dispose of according to federal, state and local regulations. Can be incinerated in approved facility if not in closed containers. Handling and Storage Precautions: Keep container tightly closed. Store in a cool dry place. Wash with soap and water before eating, drinking, smoking or using toilet facilities. Launder contaminated clothing before reuse. Transportation Data: See Section I Other Precautions: KEEP OUT OF REACH OF CHILDREN! VIII. Control Measures Respiratory Protection: Use respiratory protection if vapor levels are at or above TLV Levels. (Use NIOSH approved respirator). Ventilation: Use only in well ventilated areas. Protective Gloves: Chemical resistant gloves Eye Protection: Safety goggles Hygienic Practices: Good general cleanliness and hygiene. Wash skin and hands after use. Disclaimer: This Safety Data Sheet was prepared to protect against any reasonable exposure to consumers or employees arising out of the intended use of the product and to provide them with information regarding potential hazards contained in the product. Under varied circumstances the hazardous ingredients may pose a lesser or greater hazard. Because of the scientific data contained in these sheets was obtained from tests performed by agencies other than RCA Rubber Company, the company cannot guarantee its accuracy. RCA Rubber Company makes no warranty of any kind, expressed or implied. The user must assume all risk and liability resulting from reliance on the information contained on this Material Safety Data Sheet and the use of this product, whether used in combination with other products or singly. I. Chemical Product and Company Identification Material Identity HMIS H 2 / F 0 / R 1 / P B Product Code and Name: #5 Solvent-free Epoxy Adhesive, Part “B” Product Class: Adhesive DOT Class: Not Regulated –Limited Quantity ORM-D Manufacturer RCA Rubber Company 24 Hour Emergency Chem-Tel 1(800)255-3924 1833 East Market Street Akron, Ohio 44305 Date Prepared October 26, 1999 Date / Revised: November 7, 2012