RAPID BLANKET RESTORER

HMIS CODES

H-3; F-0; R-0; Othr-0 IV. Health Hazard Data Potential Effects of a Single Acute Overexposure: Eyes: May cause pain, moderate eye irritation that may be slow to heal and slight corneal injury. Vapors may irritate eyes. May cause caustic-like burns. Skin: Prolonged or repeated exposure may cause skin irritation, even a burn. Repeated contact may cause drying or flaking skin. May cause more severe response to skin. Extensive skin contact, such as immersion should be avoided. Ingestion: Can cause severe and permanent damage to digestive tract. Causes severe pain, nausea, vomiting, diarrhea and shock. DO NOT IDUCE VOMITING. Inhalation: Effects may be delayed (chronic). Causes chemical burns to respiratory tract and may target liver. Exposure to levels over 1,000 ppm may affect the central nervous system and cause dizziness or drunkeness. Exposure to levels as low as 10,000 ppm can cause unconsciousness and death by asphyxiation. May cause convulsion or shock. May have cardiac effects including elevation of carboxyhemoglobin. Prolonged and repeated skin contact may cause Chronic: dermatitis. Repeated inhalation may cause chronic bronchitis. V. First Aid Eyes: Flush with plenty of water for 15 minutes occasionally lifting upper and lower lids. Seek medical aid. Flush affected area of skin with plenty of soap and water for at least Skin: 15 minutes while removing contaminated clothing. Ingestion: DO NOT INDUCE VOMITING. Never give anything by mouth to an unconscious person. If conscious give large amounts of water. Seek medical aid immediately. Inhalation: Remove from exposure to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Seek medical aid immediately. Notes to Treat symptomatically and supportively. Physician: VI. Fire Fighting Measures General Information: Sealed containers can build up pressure if exposed to heat and/or fire. As in any fire war self-contained breathing apparatus in pressure demand mode. Vapors can travel to a source of ignition and flashbacks may occur. Extinguishing Media: For small fires, use dry chemical, carbon dioxide, or alcohol resistant foam. Hazardous Products of Carbon Dioxide, Carbon Monoxide, Chlorine, Combustion: Hydrogen Chloride, Phosgene. VII. Accidental Release Measures Spills and Leaks: Absorb spill with inert material, (e.g. dry sand or earth), and place into a chemical waste container for proper disposal in accordance with local, state and federal guidelines. Handling: Wash thoroughly after handling. Remove contaminated clothing and wash before re-use. Use with adequate ventilation. Keep container tightly closed, avoid skin contact.

Storage

Store in cool, dry, well ventilated area away from incompatible substances such as amines, reactive metals such as aluminum and magnesium, strong alkalies and strong oxidizing agents. VIII. Exposure Controls, Personal Protection Equipment Engineering Use adequate general or local exhaust ventilation to keep airborne Controls: concentrations below the OSHA permissable exposure limit of 25ppm. Personal Protective Equpment: Eyes: Wear appropriate eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN 166. Skin: Wear appropriate protective clothing to prevent skin exposure Respirators: Follow OSHA respirator regulations found in 29 CFR 1910.134 and 1910.1052 or European standard EN 149 for approved respirator when necessary. IX. Stability and Reactivity Chemical Stability Stable under normal temperature and pressures. Conditions to Avoid: Contact with amines, reactive metals such as aluminum and magnesium, strong alkalies and strong oxidizing agents. Hazardous Decomposition Carbon Monoxide, Carbon Dioxide, Chlorine, Products: Hydrogen Chloride and Phosgene.