Note: Ingredients listed on restricted chemical lists
EC/CAS
238-878-4/14808-60-7
Name of the chemical
Silica, crystalline
Concentration
<35%
EC/CAS
244-492-7/21645-51-2
Name of the chemical
Aluminium hydroxide
Concentration
<8%
EC/CAS
215-282-2/1317-80-2
Name of the chemical
Titanium dioxide in powder form containing 1 % or more of particles with aerodynamic diameter ≤ 10 μm
Concentration
<0.6%
EC/CAS
236-675-5/13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
0.6%
EC/CAS
215-138-9/1305-78-8
Name of the chemical
Calcium oxide
Concentration
<0.2%
EC/CAS
215-570-8/1332-37-2
Name of the chemical
iron oxide
Concentration
<0.2%
EC/CAS
215-171-9/1309-48-4
Name of the chemical
magnesium oxide
Concentration
<0.2%
General Information
Version
1.2
Revision date
2023-04-18
Product name
QUANTUM QUARTZ LOW SILICA CONTENT ENGINEERED STONE
1.2.1 Relevant identified uses
BENCHTOPS ● CONSTRUCTION INDUSTRY ● VANITIES
supplier name
QUANTUM QUARTZ
Icons in SDS
Company Information
company name
QUANTUM QUARTZ
e-mail address of the competent person responsible for the Safety Data Sheet
rada.b@wk.com.au
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H350i, H372
Hazard statements
Code
Statements
H350i
May cause cancer by inhalation
Section 2
SECTION 2: Hazards identification
Physical hazards
Not classified as a Physical Hazard
Health hazards
Carcinogenicity Category 1A Specific Target Organ Toxicity (Repeated Exposure) Category 1
Environmental hazards
Not classified as an Environmental Hazard
Signal word
DANGER
Hazard statements
H350i May cause cancer by inhalation. H372 Causes damage to organs through prolonged or repeated exposure.
Prevention
P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P260 Do not breathe dust/fume/gas/mist/vapours/spray. P264 Wash thoroughly after handling. P270 Do not eat, drink or smoke when using this product. P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection. P284 Wear respiratory protection.
Response
P308 + P313 IF exposed or concerned: Get medical advice/ attention.
Storage
P405 Store locked up.
Disposal
P501 Dispose of contents/container in accordance with relevant regulations.
Other hazards
The solid product as supplied is classified as non-hazardous under normal conditions and does not present an inhalation, ingestion, skin, or eye hazard. However, dust created when the product is cut, grinded and machined may contain crystalline silica some of which may be respirable (particles small enough to go into deep parts of the lung when breathed in)
