Note: Ingredients listed on restricted chemical lists
EC/CAS
7631-86-9
Name of the chemical
Silver adsorbed on silicon dioxide
Concentration
25-28%
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
1%
General Information
Revision date
2022-09-28
Product name
Ceramic Coating
1.2.1 Relevant identified uses
Car detailing
supplier name
PureWax Ltd
Icons in SDS
Company Information
company name
PureWax Ltd
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H227, H304
Hazard statements
Code
Statements
H227
Combustible liquid
Section 2
SECTION 2: Hazards identification
Notice 2017 This product is not classified as a Dangerous Good for Transport. This product is classified as hazardous according to criteria in the EPA Hazardous Substances (Hazard Classifications) Notice 2020. HSNO APPROVAL NUMBER: HSR002657
HSNO Classifications
3.1D Combustible liquid 6.1E Aspiration hazard
2.1 Classification of the substance or mixture
Flammable liquid – Category 4
Aspiration hazard
Category 1
Hazard statements
H227 Combustible liquid H304 May be fatal if swallowed and enters airways.
Hazard pictograms
1 DANGER
Prevention
P210 – Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking. P280 - Wear protective gloves, protective clothing, eye protection, face protection.
Response
P301 + P310 - IF SWALLOWED: Immediately call a POISON CENTRE or doctor. P331 – Do NOT induce vomiting. P370 + P378 – In case of fire: Use water fog, foam, carbon dioxide, or dry powder, to extinguish.
Storage
P403 – Store in a well-ventilated place. P405 – Store locked up.
Disposal
P501 - In accordance with the EPA Hazardous Substances (Disposal) Notice 2017. Dispose of via an approved waste disposal contractor. Refer to Section 13 of the SDS.
Further information
This product contains Titanium Dioxide which is a suspected carcinogen. However, the route of exposure is via inhalation of dust. As this product is a liquid, health hazards related to dust inhalation are not considered significant. However, a potential carcinogenic hazard may be present for any processes that result in formation of airborne dust, such as grinding or sanding of painted surfaces. A health and safety hazard risk assessment should be completed, and appropriate protection measures put in place where these processes are carried out.