Proteus Pro-Felt Endura AVCL Sanded

SECTION 2: Hazards identification

According to Regulation (EC) No. 1272/2008 (CLP) Classification of the substance or mixture All following hazards refer to the partial melted hot product above 80°c during application

2.2 Label elements

Warning! Product is heavy! 20-40Kg per roll (felt type dependant), Use MHE or a two person lift, refer to company manual handling risk assessment procedures before attempting to move product, see HSE L23 for further guidance.

Hazard pictograms

Not applicable.

Signal word

Not applicable.

Hazard statements

Not applicable.

Precautionary statements

General -

Prevention

Avoid release to the environment. (P273)

Response

-

Storage

-

Disposal

Dispose of contents/container in accordance with local regulation. (P501)

Hazardous Ingredients

None known.

Additional information

Danger of second degree burn during application by gas-torch of the product. Contact of molten hot product with water, may occur explosively causing boiling of water and splash of hot product. EUH210, Safety data sheet available on request.

2.3 Other hazards

Additional warnings This mixture/product does not contain any substances considered to meet the criteria classifying them as PBT and/or vPvB. This product does not contain any substances considered to be endocrine disruptors in accordance with the criteria set out in Commission Delegated Regulation (EU) 2017/2100 or Commission Regulation (EU) 2018/605.

2.1 Classification of the substance or mixture

All following hazards refer to the partial melted hot product above 80°c during application. Not classified according to Regulation (EC) No. 1272/2008 (CLP) as retained and amended in UK law. The product covered by this document is not subject to issuance of Material/Safety Data Sheets (MSDS/SDS) and is therefore provided on a voluntary basis.