(Produced in China)

SECTION 2: Hazards identification

NFPA Codes Health 1 Fire: 2 Reactivity: 0 (Degree of Hazard: 4=Extreme 3=High 2=Moderate 1=Slight 0=Insignificant)

Potential health effects

On Skin: Irritant, may cause temporary redness. Mild local irritation and sensitization. Intensive or continuous contact with skin may cause dermatitis. On Eyes: Irritant, may cause burning, redness, pain. By Accidental Ingestion: Harmful if ingested, gastrointestinal irritation. Abdominal pain, nausea, vomiting, dizziness. By Inhalation: Irritant to respiratory tract, sore throat, coughing, shortness of breath, dizziness, nausea. By Pressure Injection: Injection of all products will cause severe internal damage if not properly treated. Other: Kidney damage may occur (route of exposure not reported). 4. FIRST AID MEASURES EMERGENCY AND FIRST AID PROCEDURES: Skin Contact: Wash affected area with copious amounts of soap and water. Eye Contact: Remove any contact lenses at once. Flush eyes well with large quantities of water for at least 15 min. See physician immediately. Accidental For small amounts, give milk of magnesia or a glass or two of water or milk. For Ingestion: large quantities, consult a physician. Inhalation: If symptoms of overexposure are experienced, evacuate to fresh air. If symptoms persist, seek medical attention. 5. FIRE & EXPLOSION HAZARD DATA Flash Point (TCC): 115F (46.1C) Identification No.: UN 2052 Extinguishing Media: Regular Foam, COB2 B, Dry Chemical (Class B) Flammable Limits: Not Available (% by volume) Special Fire Fighting Procedures and Equipment: Do NOT use water. As with any fire situation, full face, self-contained breathing apparatus and appropriate protective clothing should be worn. Under fire conditions, this product may release CO, CO B2 B, and other decomposition products of undetermined hazard. Water is unsuitable for use on burning material, but may be used to cool containers exposed to heat. 6. SPILL OR LEAK PROCEDURES Steps to be Taken in Case Material is Released or Spilled: Use protective gloves to avoid skin contact. Small spills can be wiped up with vermiculite or other suitable absorbent material and removed to an approved disposal container. Large spills should be absorbed by dirt, sand, or other suitable absorbents for disposal. Do not hose spills down drains. Move leaking containers to well ventilated area. No Smoking. Eliminate any source of ignition. Avoid inhalation. Use NIOSH-approved respiratory protection device. Waste Handling & Disposal Method: Dispose of in accordance with Federal, State and Local environmental regulations. 7. SPECIAL PRECAUTIONS Handling and Storage Precautions: Store in glass, tin-lined, stainless steel or epoxy-lined containers to preserve quality. Do not store in plastic. Store in closed containers away from heat or sources of ignition and oxidizing materials. Protect against physical damage to containers. Avoid inhalation and contact with skin and eyes. Other Precautions: Do not dispose of solvent or oil-soaked combustible materials (rags, paper, etc.) in an open container or trash can. Place rags in approved waste cans or soak with water. 8. OCCUPATIONAL PROTECTIVE MEASURES Respiratory Protection: Not normally needed in well ventilated areas. If vapor concentration is high, use NIOSH-approved respiratory protection device. Ventilation: General mechanical ventilation (to reduce fumes). Protective Gloves: Neoprene or Rubber. Eye Protection: OSHA-approved safety glasses with side shields. Other Protective Equipment: Eye bath and safety shower. Work/Hygienic Practices: Good personal hygiene practices should be used. Wash after any contact, before eating, and at the end of the work period. 9. PHYSICAL/CHEMICAL CHARACTERISTICS Boiling Point: 351F Odor: Mild Pine aroma (760 mm Hg) (177.2C) Vapor Pressure < 2mm Vapor Density: 4.80 (mmHg @ 20C) (Air = 1) Specific Gravity: 0.850 - 0.875 Refractive Index: 1.468 – 1.477 (H2O =1) (@ 20C) Solubility in Water: Insoluble Evaporation Rate: 4.4 (butyl acetate = 1) Page 2 of 4 Pages 10. REACTIVITY DATA Stability: Stable under ordinary conditions of use and storage. Hazardous Decomposition Products: Burning produces Carbon Monoxide and/or Carbon Dioxide. Hazardous Polymerization: Will not occur. Incompatibilities: Avoid strong oxidizing agents. Do not store in plastic containers. Avoid exposure to sparks, heat and flames. 11. HEALTH HAZARD DATA Carcinogenicity: N/A NTP: N/A OSHA: Combustible Liquid IARC: N/A Signs and Symptoms of Acute and Chronic Exposure: Eye, skin and mucous membrane irritation Primary Routes of Entry: Inhalation and Absorption Medical Conditions Aggravated: Eye, skin and upper respiratory inflammation.