Note: Ingredients listed on restricted chemical lists
EC/CAS
919-30-2
Name of the chemical
3-aminopropyltriethoxysilane
Concentration
N/A
General Information
Version
19
Revision date
2017-04-26
Product name
BRUGAL GALVAPAS 320
Emergency telephone
800-424-9300
Icons in SDS
Company Information
company name
PROC OAT TECNOLOGIAS, S.L
e-mail address of the competent person responsible for the Safety Data Sheet
hammade@teccoat-usa.com
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H315, H317, H319
Hazard statements
Code
Statements
H315
Causes skin irritation
Section 2
2.2 Label elements
This productis labelled with the signal word WARNING
Hazard statements
H319 Causes serious eye irritation. H315 Causes skin irritation. H317 May cause an allergic skin reaction.
Precautionary statements
P337+P313 If eye irritation persists: Get medical advice/attention. P280B Wear protective gloves and eye protection . P303+P3614P353-P352-P312 IF ON SKIN or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. Wash with plenty of soap and water. Cal a POISON CENTER or doctor/physician if you feel unwell. P333+P313 If skin irritation or rash occurs: Get medical advice/attention. P305+P351+P338-P310 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately calla POISON CENTER or doctor/physician. P50 1c . Dispose of cormtents/container as hazardous waste.
Supplemental label elements
None.
Hazardous Ingredients
3-aminopropyltriethox ysilane
Other physicochemical hazards
No other relevant adverse effects are known
Potential health effects
No other relevant adverse effects are known.
Environmental effects
Does not contain substances that fulfil the PBT criteria Page 2/ 10
2.1 Classification of the substance or mixture
(2) Moderate health hazard (0) Minimal flammability hazard (1) Low physicochemical hazard (B) Safety glasses and gloves Note: HMIS Hazard Ratings involve data and interpretations that may vary from company to company. They are intended only for rapid, general identificacion of the magnitude of the specific hazard. To deal adequately with the safe handling of the material, all the information contained in this MSDS must be considered. Note: When in section 3 a range of percentages is used, the health and environmental hazards descrbe the effects of the highest concentration of each component, but below the maximum value.