Just Rite - Aerosol

Hazard statements (CLP)

H222, H229, H280, H350

Code

Statements

H222

Extremely flammable aerosol

SECTION 2: Hazards identification

(29 CFR 1910.1200) GHS CLASSIFICATION SIGNAL SYMBOL Aerosols - Category 1 WORD Gases Under Pressure Liquefied Gas DANGER Carcinogenicity - Category 1B Safety data sheet prepared in accordance to the United States

Precautionary statements

General: P101 - If medical advice is needed, have product container or label at hand. P102 - Keep out of reach of children. P103 - Read label before use.

Prevention

P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P211 - Do not spray on an open flame or other ignition source. P251 - Pressurized container: Do not pierce or burn, even after use. P201 - Obtain special instructions before use. P202 - Do not handle until all safety precautions have been read and understood. P280 - Wear protective gloves, protective clothing, eye protection/face protection.

Response

P308 + P313 - IF exposed or concerned Get medical advice/attention

Storage

P410 + P412 - Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F. P405 - Store locked up. P410 + P403 - Protect from sunlight. Store in a well-ventilated place.

Disposal

P501 - Dispose of contents/container to disposal recycling center. Under RCRA it is the responsibility of the user of the product to determine at the time of disposal whether the product meets RCRA criteria for hazardous waste. Waste management should be in full compliance with federal, state and local laws.

2.3 Other hazards

No additional information available.

2.1 Classification of the substance or mixture

SIGNAL SYMBOL: Aerosols - Category 1 WORD: Gases Under Pressure Liquefied Gas DANGER Carcinogenicity - Category 1B Safety data sheet prepared in accordance to the United States Occupational Safety and Health Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace Hazardous Materials Information System (WHMIS). HAZARD STATEMENTS: H222 - Extremely flammable aerosol H229 - Contains gas under pressure; may explode if heated. H280 - Contains gas under pressure; may explode if heated. H350 - May cause cancer. PRECAUTIONARY STATEMENTS: General: P101 - If medical advice is needed, have product container or label at hand. P102 - Keep out of reach of children. P103 - Read label before use. Prevention: P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P211 - Do not spray on an open flame or other ignition source. P251 - Pressurized container: Do not pierce or burn, even after use. P201 - Obtain special instructions before use. P202 - Do not handle until all safety precautions have been read and understood. P280 - Wear protective gloves, protective clothing, eye protection/face protection. Response: P308 + P313 - IF exposed or concerned: Get medical advice/attention. Storage: P410 + P412 - Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F. P405 - Store locked up. P410 + P403 - Protect from sunlight. Store in a well-ventilated place. Disposal: P501 - Dispose of contents/container to disposal recycling center. Under RCRA it is the responsibility of the user of the product to determine at the time of disposal whether the product meets RCRA criteria for hazardous waste. Waste management should be in full compliance with federal, state and local laws. HAZARDS NOT OTHERWISE CLASSIFIED (HNOC): No additional information available. 3. Composition / Information on Ingredients Chemical Name CAS Concentration % by Weight MINERAL SEAL OIL 0064742-46-7 48% - 73% MINERAL OIL, PETROLEUM DISTILLATES, 0064742-52-5 35% - 53% HYDROTREATED (MILD) HEAVY NAPHTHENIC CO2 0000124-38-9 2% - 4% Specific chemical identity and/or exact percentage (concentration) of the composition has been withheld to protect confidentiality. 4. First Aid Measures EMERGENCY OVERVIEW EYES: Remove source of exposure or move person to fresh air. Rinse eyes cautiously with lukewarm, gently flowing water for several minutes, while holding the eyelids open. Remove contact lenses, if present and easy to do. Continue rinsing for a duration of 15-20 minutes. Take care not to rinse contaminated water into the unaffected eye or onto the face. If eye irritation persists: Get medical advice/attention. SKIN: Take off contaminated clothing, shoes and leather goods (e.g. watchbands, belts). Wash with plenty of lukewarm, gently flowing water for a duration of 15-20 minutes. If skin irritation occurs: Get medical advice/attention. Wash contaminated clothing before re-use. IF exposed or concerned: Get medical advice/attention. INHALATION: Remove source of exposure or move person to fresh air and keep comfortable for breathing. If exposed/If you feel unwell/If concerned: Call a POISON CENTER/doctor. Eliminate all ignition sources if safe to do so. INGESTION: Immediately call a POISON CENTER/doctor. Do NOT induce vomiting. If vomiting occurs naturally, lie on your side, in the recovery position. MOST IMPORTANT SYMPTOMS/EFFECTS, ACUTE AND DELAYED: No data available. INDICATION OF IMMEDIATE MEDICAL ATTENTION AND SPECIAL TREATMENT NEEDED: No data available. 5. Fire-Fighting Measures SUITABLE FIRE EXTINGUISHING MEDIA: Dry chemical, foam, carbon dioxide. Water spray may be useful in minimizing or dispersing vapors and to protect personnel. Carbon dioxide can displace oxygen. Use caution when applying carbon dioxide in confined spaces. Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam. Sand or earth may be used for small fires only. Do not direct a solid stream of water or foam into hot, burning pools this may results in frothing and increase fire intensity. UNSUITABLE FIRE EXTINGUISHING MEDIA: No data available. SPECIFIC HAZARDS ARISING FROM THE CHEMICAL: Contents under pressure. Keep away from ignition sources and open flames. Exposure of containers to extreme heat and flames can cause them to rupture often with violent force. During a fire, irritating and highly toxic gases may be generated during combustion or decomposition. High temperatures can cause sealed containers to rupture due to a buildup of internal pressures. Cool with water. Empty Containers retain product residue which may exhibit hazards of material, therefore do not pressurize, cut, glaze, weld or use for any other purposes. Container could potentially burst or be punctured upon mechanical impact. SPECIFIC FIRE-FIGHTING PRECAUTIONS: Isolate immediate hazard area and keep unauthorized personnel out. Stop spill/release if it can be done safely. Move undamaged containers from immediate hazard area if it can be done safely. Water spray may be useful in minimizing or dispersing vapors and to protect personnel. Water may be ineffective but can be used to cool containers exposed to heat or flame. Caution should be exercised when using water or foam as frothing may occur, especially if sprayed into containers of hot, burning liquid. Dispose of fire debris and contaminated extinguishing water in accordance with official regulations. SPECIAL PROTECTIVE EQUIPMENT FOR FIREFIGHTERS: Wear protective pressure self-contained breathing apparatus (SCBA) and full turnout gear. 6. Accidental Release Measures EMERGENCY PROCEDURE: ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Do not touch or walk through spilled material. Isolate hazard area and keep unnecessary people away. Remove all possible sources of ignition in the surrounding area. Notify authorities if any exposure to the general public or the environment occurs or is likely to occur. If spilled material is cleaned up using a regulated solvent, the resulting waste mixture may be regulated. PROTECTIVE EQUIPMENT: Wear liquid tight chemical protective clothing in combination with positive pressure self-contained breathing apparatus (SCBA). PERSONAL PRECAUTIONS: Avoid breathing vapor. Avoid contact with skin, eye or clothing. ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Do not touch damaged containers or spilled materials unless wearing appropriate protective clothing. ENVIRONMENTAL PRECAUTIONS: Stop spill/release if it can be done safely. Prevent spilled material from entering sewers, storm drains, other unauthorized drainage systems and natural waterways by using sand, earth, or other appropriate barriers. METHODS & MATERIALS FOR CONTAINMENT & CLEANUP: Absorb Liquids in vermiculite, dry sand, earth, or similar inert material and deposit in sealed containers for disposal. 7. Handling and Storage GENERAL: Wash hands after use. Do not get in eyes, on skin or on clothing. Do not breathe vapors or mists. Use good personal hygiene practices. Eating, drinking and smoking in work areas is prohibited. Remove contaminated clothing and protective equipment before entering eating areas. Eyewash stations and showers should be available in areas where this material is used and stored. VENTILATION REQUIREMENTS