ABS Sheet

SECTION 2: Hazards identification

(29 CFR 1910.1200) This mixture has not been evaluated as a whole for health effects. Exposure effects listed are based on the existing health data for individual components which comprise the mixture. i. The ingredients in this product are bound in a thermoplastic resin matrix. In accordance with GHS for the classification of the product, the hazard potentia! may be assessed with respect to the physic-chemical form and/or bioavailability of the individual components in the thermoplastic resin. ii. Where GHS classifications are shown below, these are based on individual components in the thermoplastic resin matrix. Under typical use conditions for the product, these hazardous components are unlikely to contribute to the workplace exposure. However, some vapors may be released upon heating and the end user must take the necessary precautions to protect employees from exposure. Please read the entire safety data sheet and/or consult an EHS professional for a complete understanding.

Signal word

None

Hazard statements

None

Precautionary statements

This product contains no substances which, at their given concentration, are considered to be hazardous to health.

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood, Wash thoroughly after handling. Wear protective gloves/protective clothing/eye protection/face protection.

Response

If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists; Get medical advice/attention.

Storage

No information available

Disposal

Dispose of contents/container In accordance with Plastics Corperation Ex f F2] NA PLASTICS CORPORATION A subs‘dittry of ICC Indu stakes inc 7 Prlimex Priviex Design & Fabrication Primex Color, Compounding & Additives local/regional/national/international regulation for hazardous wastes.

2.3 Other hazards

COMBUSTIBLE DUST: If small particles are generated during further processing, handling, or by other means, combustible dust concentrations in air may form. Fine dust clouds may form explosive mixtures with air. Handling and/or processing of this material may generate a dust which can cause mechanical irritation of the eyes, skin, nose and throat. In the event that combustible dust is generated, the hazard is posed only by the size of the particle not its chemical content because all monomers, additives and pigment are totally encapsulated within the resin and cannot be released in pure form.

Additional information

Can burn in a fire creating dense, toxic smoke. Molten plastic can cause severe thermal burns. Fumes produced during melt processing may cause eye, skin and respiratory tract irritation. Severe over-exposure may result in nausea, headache, chills and fever. See below far additional effects.

2.1 Classification of the substance or mixture

None Signal word: None Hazard statements: None