None

2.1 Classification of the substance or mixture

DOT 8 OSHA A pot life. Thoroughly mix materials using a low speed drill with a mixing paddle. Scrape the sides and bottom of the pail while Health & Safety mixing. Note: Larger batches exotherm and set up faster than Safety: “B” component contains amines and may cause severe small batches. burns upon skin contact for any length of time. Use OSHA- approved personal protective equipment (PPE), including Pump Application: This product is ideally suited for use with a safety glasses, gloves and confined space equipment/ two-component injection pump or Quick Mix cartridge system. procedures if applicable. Avoid skin contact; do not ingest. See SDS for complete safety precautions. For professional use Material Preparation: Pre-condition material to between 70 only . and 80ºF (21 - 27ºC). First Aid Limitations: Cold temperatures will slow down reaction time Eye Contact: Immediately flush with large amounts of water. and increase viscosity. Do not use below 32ºF (0ºC) as ice crys- Seek medical attention. Inhalation: Move to fresh air if tals in the concrete will inhibit bond. Material that is off ratio or symptoms occur. If breathing is difficult, seek medical not mixed thoroughly will not cure to full strength and may attention. Ingestion: Seek medical attention immediately. remain tacky indefinitely. Skin Contact: Wipe off contaminated area and wash with soap and water immediately.

Storage

Clean Up Store in dry environment between 40 and 80°F Manufacturing (4 and 27°C). Do not allow to freeze. Shelf Life: 1 year from Products are manufactured by Prime Resins, Inc. in the U.S.A. date of manufacture in unopened containers properly stored. under strict quality assurance practices at our Conyers, GA Protect from moisture. plant. Clean Up: Clean off skin with soap and water immediately. Warranty & Disclaimer Prime Resins, Inc. warrants its products to be free from manufacturing defects and that products meet the published characteristics when tested in accord- ance with ASTM and Prime Resins standards. No other warranties by Prime Resins, Inc. are expressed or implied, including no warranty of merchantability or fitness for a particular purpose. Prime Resins, Inc. will not be liable for damages of any sort resulting from any claimed breach of warranty. Prime Resins’ liability under this warranty is limited to replacement of material or refund of sales price of the material. There are no warranties on any product that has exceeded the “shelf life” or “expiration date” printed on the package label. Head Office: 2291 Plunkett Road, Conyers, GA 30012 A USL Group Company T 770-388-0626 F 770-388-0936 W www.primeresins.com E: info@primeresins.com