PRB RENDER BEAD ADHESIVE

2.3 Other hazards

Not applicable. This mixture does not contain any notifiable substances. - 1 - - 2 - 4.1. Description of first aid measures General: No special measures are required. If you feel unwell, seek medical advice. After inhalation: Remove the affected person into fresh air. Respiratory problems: Consult a doctor / medical service 4.2. In the event of contact with eyes Wash with flowing water for some minutes, keeping eyes well open. If irritation persists, seek medical attention. In the event of an allergic reaction, seek medical attention. 4.3. In the event of contact with skin PRB RENDER BEAD ADHESIVE is not irritating to the skin. If an irritation occurs, wash first with water and then with soap and water. If irritation persists, seek medical attention. In the event of an allergic reaction, seek medical attention. If the contaminated area is widespread and/or there is damage to the skin, a doctor must be consulted or the patient transferred to hospital. 4.4. Ingestion Clean the oral cavity. Rinse mouth with water. Consult a doctor / medical service if you feel unwell. 4.5. Most important symptoms and effects, both acute and delayed 4.5.1 Acute symptoms After inhalation: No effects known. After skin contact: No effects known. After eye contact: No effects known. After ingestion: No effects known. 4.5.2 Delayed symptoms No effects known. 4.6. Indications of any immediate medical attention and special treatment needed If applicable and available, it will be listed below. 5.1 Extinguishing media The substance itself is not flammable. Other surrounding packaging materials could be flammable. Adapt the fire fighting measures depending on the fire risk of the surrounding combustible material. 5.1.1 Suitable extinguishing media: Adapt extinguishing media to the environment. 5.1.2 Unsuitable extinguishing media: No unsuitable extinguishing media known. 5.2 Special hazards arising from the substance or mixture Upon combustion: CO and CO2 are formed. 5.3 Advice for firefighters 5.3.1 Instructions: No specific fire-fighting instructions required. 5.3.2 Special protective equipment for fire-fighters: Gloves. Safety glasses. Protective clothing. Heat/fire exposure: compressed air/oxygen apparatus. 6.1. Personal precautions, protective equipment and emergency procedures Gloves. Safety glasses. Protective clothing 6.2. Environmental precautions Prevent any material from entering drains or waterways. Contain released substance, pump into suitable containers. Use appropriate containment to avoid environmental contamination. 6.3. Methods and material for cleaning and recycling systems Take up liquid spill into inert absorbent material. Scoop absorbed substance into closing containers. Clean contaminated surfaces with an excess of water. Wash clothing and equipment after handling. Dispose safely into suitable waste containers according to local rules. 6.4. Environmental precautions See heading 13. Requirements relating to storage premises apply to all facilities where the product is handled. Individuals with a history of skin sensitisation should wear suitable protective clothing. 7.1. Precautions for safe handling Observe normal hygiene standards. Keep container tightly closed. 7.2. Warehousing conditions, conditions for safe storage Store in covered area with undamaged packaging. If possible, on racking. 7.2.1 Safe storage requirements: Keep container in a well-ventilated place. Store at room temperature. Keep only in the original container. Meet the legal requirements. Max. storage time: 1 year(s). 7.2.2 Keep away from: No data available. 7.2.3 Suitable packaging material: Synthetic material. 7.2.4 Non suitable packaging material: No data available. 7.3. Specific end use(s) If applicable and available, exposure scenarios are attached in annex. See information supplied by the manufacturer. 8.1. Control Parameter 8.1.1 Occupational exposure a) Occupational exposure limit values If limit values are applicable and available these will be listed below. b) National biological limit values If limit values are applicable and available these will be listed below. 8.1.2 Sampling methods If applicable and available it will be listed below. 8.1.3 Applicable limit values when using the substance or mixture as intended If limit values are applicable and available these will be listed below. 8.1.4 DNEL/PNEC values If applicable and available it will be listed below. 8.1.5 Control parameters If applicable and available it will be listed below. 8.2. Exposure controls The information in this section is a general description. If applicable and available, exposure scenarios are attached in annex. Always use the relevant exposure scenarios that correspond to your identified use. Breathing protection: Respiratory protection not required in normal conditions Eye protection: If necessary, use safety glasses with side protection. Prescription glasses are not considered as protection. Provide eyewash stations in facilities where the product is handled constantly. Skin protection: Use protective rubber gloves and overalls following EU Norm 89/89/CEE and EN374. Gloves must be selected according to the application, suitability and duration of use at the workstation. Wear suitable protective clothing. These clothes shall be chosen to ensure there is no inflammation or irritation of the skin at the neck and wrist by contact with the powder Work clothing worn by personnel shall be laundered regularly. After contact with the product, all parts of the body that have been soiled must be washed. 8.3. Specific hygiene measures Observe normal hygiene standards. Keep container tightly closed. Do not eat, drink or smoke during work. 9.1. Information on basic physical and chemical properties Physical state Physical form Viscous Odour Characteristic odour Odour threshold No data available Colour White Particle size Not applicable (liquid) Explosion limits Not applicable Flammability Non combustible Log Kow Not applicable (mixture) Dynamic viscosity No data available Kinematic viscosity No data available Melting point No data available Boiling point No data available Flash point No data available Evaporation rate No data available Relative vapour density No data available No data available Vapour pressure No data available No data available Solubility No data available No data available Relative density 1.4 ; 20 °C Decomposition temperature No data available No data available Auto-ignition temperature Not applicable Not applicable Explosive properties No chemical group associated with explosive properties Oxidising properties No chemical group associated with oxidising properties pH No data available

Further information

Absolute density 1400 kg/m3 ; 20℃. 10.1. Reactivity No dangerous reactions are known if stored and handled as prescribed. 4 10.2. Chemical stability Stable under normal conditions. 10.3. Possibility of hazardous reactions No data available. 10.4. Conditions to avoid No data available. 10.5. Incompatible materials No data available. 10.6. Hazardous decomposition products Upon combustion: CO and CO2 are formed. 11.1. General information on toxicology effects 11.1.1 Test results Acute toxicity Render Bead Adhesive No (test)data on the mixture available Judgement is based on the relevant ingredients Conclusion Not classified for acute toxicity Corrosion/irritation Render Bead Adhesive No (test)data on the mixture available Judgement is based on the relevant ingredients Conclusion Not classified for acute toxicity Not classified as irritating to the eyes Not classified as irritating to the respiratory system Respiratory or skin sensitisation Render Bead Adhesive No (test)data on the mixture available Judgement is based on the relevant ingredients Conclusion Not classified as sensitizing for inhalation Not classified as sensitizing for skin Specific target organ toxicity Render Bead Adhesive No (test)data on the mixture available Judgement is based on the relevant ingredients Conclusion Not classified for sub chronic toxicity Mutagenicity (in vitro) Render Bead Adhesive No (test)data on the mixture available Mutagenicity (in vivo) Render Bead Adhesive No (test)data on the mixture available Carcinogenicity Render Bead Adhesive No (test)data on the mixture available Reproductive toxicity Render Bead Adhesive No (test)data on the mixture available Judgement is based on the relevant ingredients Conclusion CMR Not classified for carcinogenicity Not classified for mutagenic or genotoxic toxicity Not classified for reprotoxic or developmental toxicity Toxicity other effects Render Bead Adhesive No (test)data on the mixture available Chronic effects from short and long-term exposure Render Bead Adhesive No effects known. 12.1. Toxicity Render Bead Adhesive No (test)data on the mixture available Judgement of the mixture is based on the relevant ingredients Conclusion Not classified as dangerous for the environment according to the criteria of Regulation (EC) No 1272/2008 12.2. Persistence and degradability Biodegradability in water: no data available 12.3. Bioaccumulative potential Render Bead Adhesive Log Kow Not applicable (mixture) Conclusion No bioaccumulation data available 12.4. Mobility in soil No (test)data on mobility of the components available 12.5. Results of PBT and vPvB assessment Due to insufficient data no statement can be made whether the component(s) fulfil(s) the criteria of PBT and vPvB according to Annex XIII of Regulation (EC) No 1907/2006. 12.6. Other adverse effects Render Bead Adhesive Global warming potential (GWP) None of the known components is included in the list of fluorinated greenhouse gases (Regulation (EC) No 517/2014). Ozone-depleting potential (ODP) Not classified as dangerous for the ozone layer (Regulation (EC) No 1005/2009). 6 The information in this section is a general description. If applicable and available, exposure scenarios are attached in annex. Always use the relevant exposure scenarios that correspond to your identified use. 13.1. Waste treatment methods 13.1.1 Provisions relating to waste Waste material code (Directive 2008/98/EC, Decision 2000/0532/EC). 08 04 10 (wastes from MFSU of adhesives and sealants (including waterproofing products): waste adhesives and sealants other than those mentioned in 08 04 09). Depending on branch of industry and production process, also other waste codes may be applicable. Can be considered as non-hazardous waste according to Regulation (EU) No 1357/2014. 13.1.2 Disposal methods Remove waste in accordance with local and/or national regulations. Remove to an authorized waste treatment plant. 13.1.3 Packaging/Container Waste material code packaging (Directive 2008/98/EC). 15 01 02 (plastic packaging). Waste Waste management is carried out without endangering human health, without harming the environment and, in particular without risk to water, air, soil, plants or animals. Recycle or dispose of waste in compliance with current legislation, via a certified collector or company. Do not contaminate the ground or water with waste, do not dispose of waste into the environment. Not subjected to transport classification and labelling. 15.1. Safety, health and environmental regulations/legislation specific for the substance or mixture Classification and labelling information included in section 2: The following regulations have been used: European legislation: VOC content Directive 2010/75/EU VOC content: < 1 % < 14 g/l National legislation: The Netherlands Render Bead Adhesive Waste identification (the Netherlands) LWCA (the Netherlands): KGA category 03. Waterbezwaarlijkheid 11. National legislation: Germany Render Bead Adhesive WGK 1; Classification water polluting based on the components in compliance with Verwaltungsvorschrift wassergefährdender Stoffe (VwVwS) of 27 July 2005 (Anhang 4). National legislation France Render Bead Adhesive No data available 7 National legislation Belgium Render Bead Adhesive No data available Other relevant data Render Bead Adhesive No data available 15.2. Chemical safety assessment No chemical safety assessment is required. Since the user's working conditions are not known by us, the information supplied on this safety data sheet is based on our current level of knowledge and on national and community regulations. The product must not be used for other uses than those specified in section 1 without having first obtained written handling instructions. It is at all times the responsibility of the user to take all necessary measures to comply with legal requirements and local regulations. The information in this safety data sheet must be regarded as a description of the safety requirements relating to the product and not as a guarantee of the properties thereof. The information in this safety data sheet is based on data and samples provided to BIG. The sheet was written to the best of our ability and according to the state of knowledge at that time. The safety data sheet only constitutes a guideline for the safe handling, use, consumption, storage, transport and disposal of the substances/preparations/mixtures mentioned under point 1. New safety data sheets are written from time to time. Only the most recent versions may be used. Old versions must be destroyed. Unless indicated otherwise word for word on the safety data sheet, the information does not apply to substances/preparations/mixtures in purer form, mixed with other substances or in processes. The safety data sheet offers no quality specification for the substances/preparations/mixtures in question. Compliance with the instructions in this safety data sheet does not release the user from the obligation to take all measures dictated by common sense, regulations and recommendations or which are necessary and/or useful based on the real applicable circumstances. BIG does not guarantee the accuracy or exhaustiveness of the information provided and cannot be held liable for any changes by third parties. This safety data sheet is only to be used within the European Union, Switzerland, Iceland, Norway and Liechtenstein. Any use outside of this area is at your own risk. Use of this safety data sheet is subject to the licence and liability limiting conditions as stated in your BIG licence agreement or when this is failing the general conditions of BIG. All intellectual property rights to this sheet are the property of BIG and its distribution and reproduction are limited. Consult the mentioned agreement/conditions for details. Abbreviations and acronyms LD50 The dose of a test substance resulting in 50% lethality in a given time period. LC50 The concentration of a test substance resulting in 50% lethality in a given period. EC50 The effective concentration of substance that causes 50% of the maximum response. ECr50 The effective concentration of substance that causes 50% reduction in growth rate. REACH Registration, Evaluation, Authorization and Restriction of Chemical Substances. CLP (EU-GHS) Classification, labelling and packaging (Globally Harmonised System in Europe)