Note: Ingredients listed on restricted chemical lists
EC/CAS
111-76-2
Name of the chemical
Ethylene glycol monobutyl ether (EGBE)
Concentration
5 - 10
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
1 - 5
General Information
Version
22
Revision date
2018-06-27
Product name
T452 FINE WHITE PEARL
Emergency telephone
52 55 5559 1588, 1-800-647-6050
Icons in SDS
Company Information
company name
PPG Industries, Inc
GHS Information
Signal word
WARNING!
Section 2
SECTION 2: Hazards identification
Emergency overview WARNING! HARMFUL OR FATAL IF SWALLOWED. CAUSES RESPIRATORY TRACT, EYE AND SKIN IRRITATION. MAY BE HARMFUL IF INHALED OR ABSORBED THROUGH SKIN. CONTAINS MATERIAL THAT CAN CAUSE TARGET ORGAN DAMAGE. Do not swallow. Avoid breathing vapor or mist. Avoid contact with eyes, skin and clothing. Use only with adequate ventilation. Keep container tightly closed and sealed until ready for use. Wash thoroughly after handling.
Potential Acute Health Effects
Inhalation May be harmful if inhaled. Irritating to respiratory system. Can irritate eyes, nose, mouth and throat. Ingestion Harmful or fatal if swallowed. Skin Harmful in contact with skin. Irritating to skin. Eyes Irritating to eyes. Over-exposure signs/symptoms Repeated exposure to high vapor concentrations may cause irritation of the respiratory system and permanent brain and nervous system damage. Inhalation of vapor/aerosol concentrations above the recommended exposure limits causes headaches, drowsiness and nausea and may lead to unconsciousness or death. There is some evidence that repeated exposure to organic solvent vapors in combination with constant loud noise can cause greater hearing loss than expected from exposure to noise alone. For many PPG products, TiO2 is utilized as a raw material in a liquid coating formulation. In this case, the TiO2 particles are bound in a matrix with no meaningful potential for human exposure to unbound particles of TiO2 when the product is applied with a brush or roller. Sanding the coating surface or mist from spray applications may be harmful depending on the duration and level of exposure and require the use of appropriate personal protective equipment and/or engineering controls (see Section 8). Medical conditions Pre-existing disorders involving any target organs mentioned in this MSDS as being at aggravated by over- risk may be aggravated by over-exposure to this product. exposure This Material Safety Data Sheet has been prepared in accordance with Canada's Workplace Hazardous Materials Information System (WHMIS). (1988 Version) See toxicological information (Section 11)