Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
1-<10
EC/CAS
7779-90-0
Name of the chemical
Trizinc bis(orthophosphate)
Concentration
1-<10
General Information
Version
10.01
Revision date
2025-02-10
Product name
WHITE KNIGHT RUST GUARD SLS ETCH PRIMER AEROSOL
1.2.1 Relevant identified uses
Coating
supplier name
PPG Architectural Coatings
Icons in SDS
Company Information
company name
PPG Architectural Coatings
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H222, H229, H304, H315, H318
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
Classification of the substance or mixture AEROSOLS - Category 1 SKIN CORROSION/IRRITATION - Category 2 SERIOUS EYE DAMAGE/EYE IRRITATION - Category 1 ASPIRATION HAZARD - Category 1
Signal word
DANGER
Hazard statements
Extremely flammable aerosol. Pressurised container: may burst if heated. May be fatal if swallowed and enters airways. Causes skin irritation. Causes serious eye damage.
Precautionary statements
General : Keep out of reach of children. If medical advice is needed, have product container or label at hand.
Prevention
Wear protective gloves. Wear eye or face protection. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not spray on an open flame or other ignition source. Wash thoroughly after handling. Do not pierce or burn, even after use.
Response
IF SWALLOWED: Immediately call a POISON CENTER or doctor. Do NOT induce vomiting. Take off contaminated clothing and wash it before reuse. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor.
Storage
Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
Not applicable.
Other hazards which do not result in classification
Prolonged or repeated contact may dry skin and cause irritation.
2.1 Classification of the substance or mixture
AEROSOLS - Category 1 substance or mixture SKIN CORROSION/IRRITATION - Category 2 SERIOUS EYE DAMAGE/EYE IRRITATION - Category 1 ASPIRATION HAZARD - Category 1