Note: Ingredients listed on restricted chemical lists
EC/CAS
238-878-4/14808-60-7
Name of the chemical
Silica, crystalline
Concentration
0.25-0.49
General Information
Revision date
2024-09-08
Product name
POLYBRITE 745
1.2.1 Relevant identified uses
Primer
Emergency telephone
1(800) 424-9300 / 1, (703) 527-3887, 1-613-996-6666
Icons in SDS
Company Information
company name
Polyglass U.S.A. Inc
e-mail address of the competent person responsible for the Safety Data Sheet
RDProductSafety@mapei.com
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H317
Hazard statements
Code
Statements
H317
May cause an allergic skin reaction
Section 2
SECTION 2: Hazards identification
2.1 Classification of the substance or mixture
Skin Sensitization, Category 1 May cause an allergic skin reaction
2.2 Label elements
Hazard pictograms and Signal Word Warning
Hazard statements
H317 May cause an allergic skin reaction.
Precautionary statements
P201 Obtain special instructions before use. P202 Do not handle until all safety precautions have been read and understood. P261 Avoid breathing mist/vapours/spray. P280 Wear protective gloves/protective clothing/eye protection/face protection. P302+P352 IF ON SKIN: Wash with plenty of water. P308+P313 IF exposed or concerned: Get medical advice/attention. P333+P313 If skin irritation or rash occurs: Get medical advice/attention. P363 Wash contaminated clothing before reuse. P501 Dispose of contents/container in accordance with applicable regulations.
Ingredient(s) with unknown acute toxicity
None Hazards not otherwise classified identified during the classification process None This product contains crystalline silica (quartz sand). IARC has classified crystalline silica as a Group 1 carcinogen. Both IARC and NTP consider silica as a known human carcinogen. Evidence is based on the chronic and long-term exposure workers have had to respirable sized crystalline silica dust particles. Because this product is in liquid or paste form, it does not pose a dust hazard; therefore, this classification is not relevant. (Note: sanding of the hardened product may create a silica dust hazard)
